Husqvarna 564xp porting

[Jamie D]

That's the million dollar question with Gilardoni jugs, I only hear negative things about them.

It's a problem for band machining some cylinders are only suitable for a base cut

 

[Tor R]

It's a problem for band machining some cylinders are only suitable for a base cut

Good point, never thought about that

 

[mainer_in_ak]

Did any of the saw porters on here cringe when they saw the finish of those 564 cylinder ports? Ewwww.

What is the weight on that ridiculously tall piston?

 

[Kongpils]

Did any of the saw porters on here cringe when they saw the finish of those 564 cylinder ports? Ewwww.

What is the weight on that ridiculously tall piston?

I did not weigh the piston. But should remember to do so as soon another one shows up. Yes the finish in the ports are very rough.

 

[MG2186]

I did not weigh the piston. But should remember to do so as soon another one shows up. Yes the finish in the ports are very rough.

All the new Husky saws are that way. Doesn’t seem to hurt their performance