MMWS (Cross Performance) Cylinders online

[rattler]

I got hosed waiting for my password to get reset. My fault, I should have just checked out as a guest, was going to grab 2 for that price.

Looking forward to seeing pics !

When they get. Here I will post pics on them for sure.

 

[RI Chevy]

Gets kinda old dosent it? Kinda like an entitled rich kid.

Certainly does Coltont. [emoji106]

 

[wcorey]

Gets kinda old dosent it? Kinda like an entitled rich kid.

It just cancels out the relentlessly positive, for me that gets kinda old too.;^)
Strive for balance in everything...

 

[RI Chevy]

I hear you Bill.

 

[Brewz]

I'm wondering how one of these would go with a 288 piston?
Get that exhaust down around 105* and keep the intake about 80* with minimal compression increase

Hmmmmmmmmm

 

[Moparmyway]

I got hosed waiting for my password to get reset. My fault, I should have just checked out as a guest, was going to grab 2 for that price.

Welp ..........
one kit is good enough to have the misses upset about, so .....................
Upset she is ..............

I'd like two, but I'll just grab the one for now - I've got to see how this looks in muh grubby hands

 

[Moparmyway]

I'm wondering how one of these would go with a 288 piston?
Get that exhaust down around 105* and keep the intake about 80* with minimal compression increase

Hmmmmmmmmm

You'd be using some JB then, eh ?

 

[dall]

Well done Mr Bruce.

you forgot the 121212 lol

 

[MustangMike]

I wanna beat on one.

If you want to make me the test, I got no problem with that!

 

[Mastermind]

If you want to make me the test, I got no problem with that!

I was planning on talking to you about that very thing. I'll send the 066 with two top ends. The Cross installed, and the OE ported and ready to bolt on. Cool?

 

[MustangMike]

Sounds extra fantastic. I'm hoping to cut & mill some large Red Oak in late Dec/Jan. That would be great Randy!

Question: It says "kit" and comes with Caber Rings, what piston (or is there a piston)???

 

[Mastermind]

Sounds extra fantastic. I'm hoping to cut & mill some large Red Oak in late Dec/Jan. That would be great Randy!

Question: It says "kit" and comes with Caber Rings, what piston (or is there a piston)???

Cross Performance piston. The quality looks pretty damn good.

 

[trooney]

@Mastermind , have you weighed a cross piston versus an OEM?

 

[Mastermind]

@Mastermind , have you weighed a cross piston versus an OEM?

No Tom.......I need to do that.

 

[angelo c]

No Tom.......I need to do that.

Randy,
I've got one on order. I have an OEM piston here as well. Any ideas if they will swap . If so I'll give a shout on the report/comparison.
Heck I got a OEM cyl here I could use too.

 

[Mastermind]

The piston should swap without issue.

 

[rattler]

Ok Men mine came in today haven't had time to do anymore than look at them but they look good to me here are a few pic,s

 

[rattler]

 

[rattler]

Sorry that the pics aren't very good I will try to do better tomorrow

 

[Frank bierce]

Good photos!! Could use some casting clean up to smooth the ports out...but not too bad!!