So what did you do today?

[Hinerman]

Took delivery of an EAVision J150 spray drone and a Winco 22kw generator.
View attachment 486290

One blade set is wider than a 5th grader !!
View attachment 486291

The controller is rather girthy as well.
View attachment 486292

What is the generator for?

 

[Bill G]

...............One blade set is wider than a 5th grader !!

View attachment 486291

It is smarter than a 5th grader also.



But a 5th grader could run it better than probably 99.9% of adults.

 

[singinwoodwackr]

What is the generator for?

Generation

 

[jblnut]

What is the generator for?

Charging the drone batteries in the field. The charger has two 30a plugs and will pull 52a when charging. It’ll charge a battery in 10 minutes. The drone will fly its cycle in 8-12 minutes depending on a number of conditions. By about the time the 20ga tank is empty the battery will be around 20% and it’ll head home. At least that’s the goal for how it should work out.

The generator will also power the 1-1/2hp pump I’ll be using to fill the drone with liquid.

 

[jblnut]

It is smarter than a 5th grader also.

But a 5th grader could run it better than probably 99.9% of adults.

No kidding. I have met some pretty dumb humans over the years. A few dumb enough that you can’t help but think the only reason they’re still here is because breathing and heart beating things are taken care of without thought. If not I doubt some would survive lol.

 

[legdelimber]

How long before the kids realize that they could tie a cargo sling to the flying sprayer and then take joy rides around the farm?

 

[TheDarkLordChinChin]

Finally got my part Chinese part OEM 660 up and running.
The wire coming from the coil to the switch had torn out, so that was the cause of it not starting all these years id say.



Fixed a few other very minor issues. The metal collar holding the rubber intake manifold to the cylinder had no bolt holding it tight. I may have stolen it for another saw some time. I found one that worked.

Got her sharpened and tuned. Good to go.

I dont like the Chinese handle on it, it feels very weak and flimsy. Im going to try and find an oem one.

Does anyone know if a 661 wrap handle will fit? Logs and saws in the uk sells them.

 

[Lions fan]

Took delivery of an EAVision J150 spray drone and a Winco 22kw generator.
View attachment 486290

One blade set is wider than a 5th grader !!
View attachment 486291

The controller is rather girthy as well.
View attachment 486292

Wonder if you could weaponize that thing? Might be a fun way to fill crop damage permits.

 

[furb]

I might even assemble the one I have in a box now
Just need a piston.
I do have a model 50, 45mm nos piston that is the same size as the 350, just flat instead of dished. Will experiment… otherwise, meteor if I can’t find a cheap oe one.

This saw wound up with 150#, cold comp with new Caber ring which ain’t bad. No base gasket, .019 sq. Opened up the ex port and lower transfers to match the base, muff mod.

They just feel “right” That was my first decent saw so maybe I’m biased. I have both versions of 346s and liked the 350 more. I run my MS261s all the time now but I need to get the 350 out again.

 

[furb]

Went to clean up the neighbors some more. Filled my 50 gallon transfer tank with heating oil and found some more snap on stuff.