HOMELITE Homelite Thread

[heimannm]

I need help from someone with a good understanding of late model Homelite saws...in this case dressed in John Deere green...

J3816



What model Homelite is this? I'm pretty sure Fossil already schooled me once but I have not been able to located that information again.

Are there other Homelite models that were also dressed up in green? Does anyone have one in really nice condition they would be interested in letting go? This could include an Efco version. Asking for a customer...

Mark

 

[They call me Mr. Kibbs]

I need help from someone with a good understanding of late model Homelite saws...in this case dressed in John Deere green...

J3816

View attachment 476384

What model Homelite is this? I'm pretty sure Fossil already schooled me once but I have not been able to located that information again.

Are there other Homelite models that were also dressed up in green? Does anyone have one in really nice condition they would be interested in letting go? This could include an Efco version. Asking for a customer...

If it's a 45 cc version it may be a Timberman. Back about 2003 I was a little thin on funds and wanted/needed a 20" chainsaw. Bought a Timberman not knowing any better, and it looks a lot like your JD. Actually not a bad saw, starts and cuts after sitting for years at a time, but should have never been paired with a 20" bar.

 

[Partner]

People buy with their eyes, so the guide bar is often too large in cheaper saws

 

[They call me Mr. Kibbs]

People buy with their eyes, so the guide bar is often too large in cheaper saws

Very true, and it only took the purchase of one 'meh' saw to point out the errors of my ways!

 

[fossil]

I need help from someone with a good understanding of late model Homelite saws...in this case dressed in John Deere green...

J3816

View attachment 476384

What model Homelite is this? I'm pretty sure Fossil already schooled me once but I have not been able to located that information again.

Are there other Homelite models that were also dressed up in green? Does anyone have one in really nice condition they would be interested in letting go? This could include an Efco version. Asking for a customer...

Mark

Doing a bit of digging, this one is a little more complicated than the last one I did some digging and I'm making some assumptions.

The 45 cc Homelite Timberman looks to share the same plastics as the John Deere J3816.



Looking at the IPL (attached) for the Timberman, it shows the 38cc version using the same cylinder as the 45cc version. The 38cc verstion is UT10927 and the 45cc versions are UT10942 and UT10946.

Unfortunately I can't find any specs on the John Deere or Homelite bore and stroke.

That's about as close as I can get.

Just a side note digging inro my diminishing memory. Poulan 34XX, 38XX and the 40cc saws all used the same 40cc cylinder. Maybe a similar case with your John Deere.

Tim

 

[heimannm]

Thank you Tim, every bit of information helps.

Mark

 

[lehman live edge slab]

Doing a bit of digging, this one is a little more complicated than the last one I did some digging and I'm making some assumptions.

The 45 cc Homelite Timberman looks to share the same plastics as the John Deere J3816.

View attachment 476410

Looking at the IPL (attached) for the Timberman, it shows the 38cc version using the same cylinder as the 45cc version. The 38cc verstion is UT10927 and the 45cc versions are UT10942 and UT10946.

Unfortunately I can't find any specs on the John Deere or Homelite bore and stroke.

That's about as close as I can get.

Just a side note digging inro my diminishing memory. Poulan 34XX, 38XX and the 40cc saws all used the same 40cc cylinder. Maybe a similar case with your John Deere.

Tim

My uncle had one of them because he was a homelite dealer back in the 80’s needless to say he could tell it wasn’t the homelite of old. John Deere had pretty much every homelite in green yellow over the time they owned them. I should have bought the homelite 250/300 in Deere trim up here when the dealer went out of business along with the super xl in Deere colors.

 

[lehman live edge slab]

I need help from someone with a good understanding of late model Homelite saws...in this case dressed in John Deere green...

J3816

View attachment 476384

What model Homelite is this? I'm pretty sure Fossil already schooled me once but I have not been able to located that information again.

Are there other Homelite models that were also dressed up in green? Does anyone have one in really nice condition they would be interested in letting go? This could include an Efco version. Asking for a customer...

Mark

Here’s some of them, I really didn’t realize they sold a green machine “by John Deere” version of a few also and I don’t own any of them just showing you a few to search for. But I will ask locally some of the guys i know

 

[LAWN BOY]

Here’s some of them, I really didn’t realize they sold a green machine “by John Deere” version of a few also and I don’t own any of them just showing you a few to search for. But I will ask locally some of the guys i know

I have a green machines saw, but I think mine is a Tanaka rebrand.
The 350cs is definitely a bucket list saw for me, Leon's is in really nice shape there. I forgot to bid on one on eBay that went dirt cheap not too long ago.