''Twas the night before the SOLMAR!

[Miller Mod Saws]

Looks pretty damn good to me.

It's much better. Need to sharpen a different chain and do some comparisons.

 

[Miller Mod Saws]

Ok here's what I did different on this saw. While new intake. I didn't lower it any this time. Just widened it and raised it.

 

[Miller Mod Saws]

On the trans. I just leveled them at 128 this go. So the secondaries are raised some towards the exhaust and just a little towards intake. Mains were raised to match.

 

[Miller Mod Saws]

Exhaust dome the same way at 105. Still widened towards one side. In this pic you can see my squish band didn't quite clean up on this cylinder I'm at .021" squish

 

[Miller Mod Saws]

The same hair cut. Lol.

 

[Mastermind]

Burred off for an old school flat top.

 

[Miller Mod Saws]

Here's where I changed it a lot. I did very little. I just clipped the corners so there wasn't a flat were the spacer and gaskets meet the cylinder

 

[A.E.E.llc]

I really like this build. I'd like to offer my service to face a piston keeping the original radius if you want to go that route.

 

[Mastermind]

I really like this build. I'd like to offer my service to face a piston keeping the original radius if you want to go that route.

Very kind of you Shawn. Way above my pay grade.

 

[Miller Mod Saws]

I really like this build. I'd like to offer my service to face a piston keeping the original radius if you want to go that route.

Thank you! I appreciate it.

 

[Miller Mod Saws]

Very kind of you Shawn. Way above my pay grade.

Not above your pay grade. Just maybe above your equipment!

 

[Deets066]

Did you leave the lowers alone on the second jug

 

[Miller Mod Saws]

Ok boys give me some opinions. I have my opinion on this saw. But here she is wearing a 20" 8-rim.

 

[RI Chevy]

Sounds real nice and strong. Good job.

 

[jacob j.]

The motor sounds real healthy. Nice work CM- sometimes it's a little tougher for a motor with a taller piston to generate as much pressure but that one sounds good.

 

[Miller Mod Saws]

Switched back to the 7-rim. And give her a little more timing.

 

[RI Chevy]

Seems much happier there. [emoji106]

 

[Miller Mod Saws]

I've been slacking but the solmar is back on the bench for some new parts. Lol.

 

[Deets066]

I've been slacking but the solmar is back on the bench for some new parts. Lol.
View attachment 45678

Which studs are those Carl?

 

[Miller Mod Saws]

Which studs are those Carl?

Not sure what ya mean. 7910 studs