''Twas the night before the SOLMAR!

[Miller Mod Saws]

You added a lot of Case volume with your spacer and opening those lowers.

Willing to try raising your uppers a bit?

I bet they need to be higher with all that extra volume.

That has crossed my mind. The prob is I opened the tunnels as well. I'm loosing to much velocity in IMO. We will see. If I jack this cylinder up. Well I'll buy another off Randy. Lol.

 

[Miller Mod Saws]

I think you lost transfer pressure.

Lol you responded while I was typing

 

[drf256]

You got flow but less velocity.

I'd open the uppers and raise them a bit.

With the dome, your numbers are artificially greater numerically, correct?

 

[Redfin]

Have you tried different muffler opening combinations? I see it like what Jason was running into opening the lowers and tunnel.

 

[Mastermind]

That has crossed my mind. The prob is I opened the tunnels as well. I'm loosing to much velocity in IMO. We will see. If I jack this cylinder up. Well I'll buy another off Randy. Lol.

No......you won't.

I'll gladly give you one though.

 

[drf256]

No......you won't.

I'll gladly give you one though.

Good Man

 

[Miller Mod Saws]

Ok boys squish cut on new cylinder and ready to go.

 

[Miller Mod Saws]

No......you won't.

I'll gladly give you one though.

 

[Mastermind]

How far is it from the top of the piston to the the top ring?

 

[Miller Mod Saws]

How far is it from the top of the piston to the the top ring?

Is this what you be after

 

[Mastermind]

What is that in 'Merican?

 

[Miller Mod Saws]

What is that in 'Merican?

.142". Lol.

 

[Mastermind]

I'd start by taking .050" off the top of the piston on a taper. Or a radius if you can.

 

[Miller Mod Saws]

I'd start by taking .050" off the top of the piston on a taper. Or a radius if you can.

I can. But I want to have this as pretty much a slide in piston. And I would want to start with a new piston to do that. As right now I think my intake needs to stay at 76. And that would drop it way down. it may come to that however. Maybe I should put a new piston in order. Lol.

 

[Mastermind]

I can. But I want to have this as pretty much a slide in piston. And I would want to start with a new piston to do that. As right now I think my intake needs to stay at 76. And that would drop it way down. it may come to that however. Maybe I should put a new piston in order. Lol.

I'm thinking of the jug height, and the weight of the slug.

 

[Miller Mod Saws]

I'm thinking of the jug height, and the weight of the slug.

I'm thinking I need to do 2 of these. On xmas saw. And find me another one and relocate the ring. Put the piston in right and cut the dome just like your saying. O ya. Lol.

 

[Redfin]

What is the minimum thickness between the top ring and crown that would be considered safe?

 

[Mastermind]

About .090

 

[Miller Mod Saws]

Sorry guys I get wrapped up in my work.

 

[Mastermind]

Sorry guys I get wrapped up in my work.

Looks pretty damn good to me.