So what did you do today?

[Stem]

when I need something from Messick's they rarely have it in stock at the Abbottstown or Carlisle location, so I just order it online & just pick it up within the next day or two, the closest one is a 20-25 min drive for me.

If I need JD parts there's 3 Atlantic Tractor locations within 30 mins (closest being about 15 mins) from my house depending on what direction I go. They also tend to keep a LOT more in stock.

 

[furb]

I buy parts from Messicks. Drove by their store on 283 in September.

You weren’t far from me. I could’ve sent you home with a load of stuff you never knew you needed.

 

[furb]

when I need something from Messick's they rarely have it in stock at the Abbottstown or Carlisle location, so I just order it online & just pick it up within the next day or two, the closest one is a 20-25 min drive for me.

If I need JD parts there's 3 Atlantic Tractor locations within 30 mins (closest being about 15 mins) from my house depending on what direction I go. They also tend to keep a LOT more in stock.

Atlantic tractor in Carlisle is probably the best JD dealer around here. I would drive past a few Deere country’s to go there for a machine

 

[furb]

My buddy got some oak delivered to his bedroom this morning so I went over after work to try to help out. Ended up helping empty the beer fridge. They were both pinned to the bed. He got himself out, she was in for two hours. They are banged up but fine. Tomorrow we need to try to get something sealed up. Most of the damaged part is removed already.

 

[Partner]

Ooo, I see you have a helicopter

 

[Powerstroke Cowboy]

You weren’t far from me. I could’ve sent you home with a load of stuff you never knew you needed.

I bet. Thats how it works. Ive bought lots of things I never knew I needed till it was seen.

 

[Partner]

It's like with a girl you see and you want to have her

 

[SawAddictedFarmer]

I ate breakfast. Now I have to go work, a roll-up door for the shop is supposed to show up and hopefully I'll get it installed. And then I stacked up two big brush piles yesterday that need burning, hopefully without lighting the rest of the woods on .

 

[drumbum]

What did I do today?.....I stopped working on the 582 'bout ten minutes ago...

Was about to get the alignment shims under the engine plate and was working the clutch and noticed the rear coupler was sliding for and aft on the input shaft of the trans.

It shattered at the pin hole. Maybe from fighting with the forward coupler pin.

Grrrrrrrrrr......

 

[SawAddictedFarmer]

Just lit the first fire of the year.

 

[dangerousatom]

Getting to be that time of the year here too

 

[Yukon Stihl]

Probably fire up my boiler system tomorrow
Using free diesel at the moment

 

[jblnut]

Fired up the wood boiler yesterday.


Roughly 25 cord by the boiler. Should be enough unless it gets butt cold for longer than normal. Those totes last a day and a half when it’s real chilly.

 

[Partner]

I have a little less

 

[jblnut]

My piles are small compared to others on here as well lol. I’d say I have around 35 cord cut up and ready to burn with another 50ish still in longer lengths waiting to get cut and split.