Saw video thread

[jmssaws]

Like mike said there everywhere.
Makes it interesting porting them,the better the stock timing the better it will run ported most everytime.

 

[PA Dan]

That's what I remember hearing. It will be a while before I can check mine. Case is blasted and getting powder.

 

[Brewz]

I would like some details on the after market one you have Jay.

 

[Brewz]

Is it a lil red barn top end?

 

[johnny5ny]

This saw is beyond strong,simply insane.

I'll say
I think I just pooped a little

 

[Brewz]

Perhaps we should start a dedicated 064 thread to discuss this further

 

[jmssaws]

Perhaps we should start a dedicated 064 thread to discuss this further

Got a cylinder thread going now

 

[junkman]

Oldie of @Mastermind did meteor top end on a 440 ,chain was kind of grabby ,made him smirk a little at the end i think .

 

[huskihl]

Oldie of @Mastermind did meteor top end on a 440 ,chain was kind of grabby ,made him smirk a little at the end i think .

His wood stove was a lot bigger back then...

 

[Toad22t]

I made a better chain and put my fancy bar on.

Where did you get the bar Jason?

 

[jmssaws]

Where did you get the bar Jason?

Definitive Dave

 

[CoreyB]

Ok I know that most saws in this thread are ported and modded. I debated putting this in because I don't want to hurt anyone's feelings. This is some Oregon chain that I sharpened two tanks ago with my granberg file n jig. So no race chain just a fire wood chain. And my bone stock 6100 trying to cut through some oak.
Don't laugh to hard.

 

[Deets066]

 

[Deets066]

Finally got the hybrid together again

 

[jmssaws]

Looks great deets

 

[Deets066]

It runs pretty good, against the odds at 20.5 degrees of blow down

 

[jmssaws]

It runs pretty good, against the odds at 20.5 degrees of blow down

More bd widens the power band which a hybrid desperately needs.
There's a very talented man in Wisconsin that said you wanted 20+ degrees of blow down on a 046.

 

[mdavlee]

Ok I know that most saws in this thread are ported and modded. I debated putting this in because I don't want to hurt anyone's feelings. This is some Oregon chain that I sharpened two tanks ago with my granberg file n jig. So no race chain just a fire wood chain. And my bone stock 6100 trying to cut through some oak.
Don't laugh to hard.

Looks strong. Only thing I didn't like was snapping the brake while the clutch was still engaged. It can snap the end off the crank if there's a weak spot. Let it go to idle and then set it.

 

[CoreyB]

Looks strong. Only thing I didn't like was snapping the brake while the clutch was still engaged. It can snap the end off the crank if there's a weak spot. Let it go to idle and then set it.

Thank you! I don't want a broken saw.

 

[Chainsaw Jim]

Ok I know that most saws in this thread are ported and modded. I debated putting this in because I don't want to hurt anyone's feelings. This is some Oregon chain that I sharpened two tanks ago with my granberg file n jig. So no race chain just a fire wood chain. And my bone stock 6100 trying to cut through some oak.
Don't laugh to hard.

Videos of stock saws are necessary to compete the spectrum.