HOMELITE Homelite Thread

[Partner]

I also found a shaft lying next to the muffler on the table and I don't know where it ended up under the starter housing

I hope this isn't part 10

 

[hacskaroly]

I hope this isn't part 10

Part 10 looks to be a roller bearing...

 

[Partner]

That's what I found next to the cylinder

 

[hacskaroly]

That's what I found next to the cylinder

Hopefully you find more than one...maybe two or three more

 

[Partner]

The engine is still intact

 

[Maintenance Chief]

After a little over a year of looking all over, finally have a good supply of new old stock homelite bars for my CS 900 EVL. No thanks to those goofy light-weight bars on an old muscle saw. Love those old solid bars!

Oregon 32" 3/8 .050
Windsor 30" 3/8 .050
GB 30" 3/8 .050

The old Windsor bars a actually a milled bar , there's quite a bit of difference in weight.

 

[Partner]

I hope this isn't part 10

The roller found is 14x4.8mm

 

[Partner]

I found some glue on the oil pump housing

 

[heimannm]

I worked on several Homelite saws over the past few months and found similar products on SEZ and XL12 models.



Mark

 

[Partner]

I suspect that it is an additional pre-filter that also seals the outer edge. Thanks to this, the filter is as good as new

 

[Partner]

I wonder what effect this had on piston burning. I need to see how air flows through this dirt

 

[Partner]

I tested it through a 2" thermo pipe and you can breathe with the filter, but I would suffocate with the black one

 

[Partner]

I put a bandage on the bottom of the handle And a 6mm square to prevent it from falling out also got a thermo pipe

 

[Partner]

I suspect that it is an additional pre-filter that also seals the outer edge. Thanks to this, the filter is as good as new

I found these black air filters and they are from a different model

 

[Partner]

Does the manual oiler button have any protection? SXL-925

 

[heimannm]

This is an XL123 but the 925 should have a similar button. Part number for the 925 is 63622.

NOS Homelite chainsaw Part No. 63622 Vintage chainsaw D23 | eBay

Find many great new & used options and get the best deals for NOS Homelite chainsaw Part No. 63622 Vintage chainsaw D23 at the best online prices at eBay! Free shipping for many products!

www.ebay.com

Mark

 

[Partner]

Is the piston pin installed correctly? The fuel tygon is too thin

 

[Maintenance Chief]

Is the piston pin installed correctly? The fuel tygon is too thin

Piston pin is correct.

 

[Yukon Stihl]

A 26 LCS question
I got a replacement seal for the flywheel side and replaced it.
Did a pressure test and found pressure coming out of a hole in the crankcase near the belt case.
My parts saw doesn’t have the hole, but has a casting mark.
Is the hole supposed to be open to crankcase pressure?
Thanks