HOMELITE Homelite Thread

[Partner]

I also found a shaft lying next to the muffler on the table and I don't know where it ended up under the starter housing

I hope this isn't part 10

 

[hacskaroly]

I hope this isn't part 10

Part 10 looks to be a roller bearing...

 

[Partner]

That's what I found next to the cylinder

 

[hacskaroly]

That's what I found next to the cylinder

Hopefully you find more than one...maybe two or three more

 

[Partner]

The engine is still intact

 

[Maintenance Chief]

After a little over a year of looking all over, finally have a good supply of new old stock homelite bars for my CS 900 EVL. No thanks to those goofy light-weight bars on an old muscle saw. Love those old solid bars!

Oregon 32" 3/8 .050
Windsor 30" 3/8 .050
GB 30" 3/8 .050

The old Windsor bars a actually a milled bar , there's quite a bit of difference in weight.

 

[Partner]

I hope this isn't part 10

The roller found is 14x4.8mm

 

[Partner]

I found some glue on the oil pump housing

 

[heimannm]

I worked on several Homelite saws over the past few months and found similar products on SEZ and XL12 models.



Mark

 

[Partner]

I suspect that it is an additional pre-filter that also seals the outer edge. Thanks to this, the filter is as good as new