Grease Monkey Garage

[mainer_in_ak]

They’re engine fart tubes

They’re fine

Hahahhahaha. The farts dont care about exauhst clamps!

 

[Sloughfoot]

I want to build a v8 runna into a crawler someday.

There’s a few of those around here.

 

[redline4]

The factory trans dipstick tube I cut down was functional but made contact with the firewall.

Bought a Lokar firewall mount one and made a bracket to hold it to the back of the cylinder head.

 

[redline4]

Left side tailpipe getting done..

 

[redline4]

And a cold start, idle sound clip

 

[LAWN BOY]

Gave the Silverado some attention today. A bit past due but gave it an oil and filter change. Also redid the wooden rear bumper since my first one busted off after swinging the rear end of the truck into a snowbank, went with much thicker lumber this time around. Also zip tied in my lower left headlight better.

 

[redline4]

Right side tailpipe happening.

 

[redline4]

It's got exhaust.

 

[Yukon Stihl]

Gave the Silverado some attention today. A bit past due but gave it an oil and filter change. Also redid the wooden rear bumper since my first one busted off after swinging the rear end of the truck into a snowbank, went with much thicker lumber this time around. Also zip tied in my lower left headlight better.View attachment 484621View attachment 484622View attachment 484623

Looks overdue for a fuel filter change

 

[redline4]

I looked at this truck on Monday for a no start.
The rear crossmember went to chow town on the fuel pump module wiring. I had looked at it a few weeks prior for some funky shifting.
Guy decided he was done with it.
Scrap yard said they would give him roughly what his bill would have been. He signed the title over and I made his bill go away..



I'm pulling the 5.3 because you never know when something will need an LS swap. Tailgate, fenders, probably doors and a few other pieces will get swapped to my shîtbôx plow truck, the brand new Goodyear Duratracs will get sold and I'll scrap the rest.