Another chainsaw dyno...

[spencerpaving]

@spencerpaving do you still have habada habada?

Absolutely....And still running good

 

[dall]

Is the Asian Saw Crown like a participation ribbon?

yes

 

[markds2]

Absolutely....And still running good

I'd love to see both what RPM that's turning ...and peak HP

 

[XP_Slinger]

Sorry, sounds too much like this butt hurt society these days. Have a set...say what you think.

Couldn’t be further from the truth Deetsy, my set is firmly in place...but I’ll leave it at that so as not to F up Joe’s thread.

 

[spencerpaving]

I'd love to see both what RPM that's turning ...and peak HP

Last I checked it was at the nygtg.....It was around 14500 in the wood...And around 17500 out...

 

[markds2]

Last I checked it was at the nygtg.....It was around 14500 in the wood...And around 17500 out...

 

[MustangMike]

I appreciate the support, but these guys don't bother me. Most of them wouldn't have the stones to try to port their own saw, OEM or Asian, and are only brave on the internet.

 

[TreeLife]

I appreciate the support, but these guys don't bother me. Most of them wouldn't have the stones to try to port their own saw, OEM or Asian, and are only brave on the internet.

Lmao when was the last time you got a good for you?

 

[Spladle160]

Lmao when was the last time you got a good for you?

Good for you Mike! You did something yourself on a reasonable budget and did a proven better job than most people probably would. As added benefits you made a few bucks for Joe and got Deets to send in that hybrid for all of us to see. I'd say it's a win, win, win!

 

[TreeLife]

Good for you Mike! You did something yourself on a reasonable budget and did a proven better job than most people probably would. As added benefits you made a few bucks for Joe and got Deets to send in that hybrid for all of us to see. I'd say it's a win, win, win!

I don't disagree in the slightest

 

[00wyk]

I'm impressed it took nearly 75 pages before a dyno thread went to *s-word.

 

[Red97]

what saw

026?

I've got a scruffy one here ...

 

[Red97]

I'm impressed it took nearly 75 pages before a dyno thread went to *s-word.

Still has hope.

Lots of cool stuffs in the mail, and a 572 here for a baseline...

 

[dall]

026?

I've got a scruffy one here ...

i May have one or two lol

 

[mdavlee]

i May have one or two lol

One or two dozen?[emoji23]

 

[Nutball]

026?

I've got a scruffy one here ...

Mine's scruffier

 

[Red97]

i May have one or two lol

Be more fun to do a long lean run? Or straight gas?

 

[Nutball]

Straight gas

 

[Red97]

Back to what @David Young suggested.

How many could port an 026 cylinder?

I think those are easy to swap.

Just use a gasket, and the same piston for all of them?

Just brainstorming some type of a build off

 

[Nutball]

I have a few 026 cylinders I could do. You'd have to watch out for 44 vs 44.7mm right? Then there's the muffler problem. You could use the same outlet, but some cylinders may be matched to a modified muffler inlet.

Then what about break in time and stuff?