I'll get it to you once the box is on the way back. Need to get everything cleaned and drained. Pit back in the boxes. Hope to get them heading back early next week.
Another chainsaw dyno...
- Thread starter Red97
- Start date
I'll get it to you once the box is on the way back. Need to get everything cleaned and drained. Pit back in the boxes. Hope to get them heading back early next week.
dustinwilt68
Wilt Built Work Saws
- Local time
- 12:05 PM
- User ID
- 1007
- Joined
- Mar 8, 2016
- Messages
- 5,933
- Reaction score
- 26,230
- Location
- Southwest PA
Dang Joe! That's runner! Very well done!
Wonkydonkey
Plastic member
- Local time
- 5:05 PM
- User ID
- 3189
- Joined
- May 14, 2017
- Messages
- 5,056
- Reaction score
- 22,237
- Location
- Sussex, UK.
Sometimes this thread move so fast, I have difficulty keeping up. It’s a great thread and
I’ve been loving reading most of it... just some times it gets boring when the knocking starts on a particular type of saw.. or manufacturer & whatever it leads onto.
I,m really enjoying the data produced in a graph But one thing I’d like to see is how two same saws cut wood with the same bar and chain and then compare the times with the graphs.. as I see some people are saying it don’t match.
anyhow carryon and keep up the good work.
I’ve been loving reading most of it... just some times it gets boring when the knocking starts on a particular type of saw.. or manufacturer & whatever it leads onto.
I,m really enjoying the data produced in a graph But one thing I’d like to see is how two same saws cut wood with the same bar and chain and then compare the times with the graphs.. as I see some people are saying it don’t match.
anyhow carryon and keep up the good work.
dustinwilt68
Wilt Built Work Saws
- Local time
- 12:05 PM
- User ID
- 1007
- Joined
- Mar 8, 2016
- Messages
- 5,933
- Reaction score
- 26,230
- Location
- Southwest PA
Pretty impressive numbers, nice job Doc!
ranchdadmike
Pinnacle OPE Member
The good Doctor builds a fine saw! Now I’m curious about my mofo 262...
- Local time
- 12:05 PM
- User ID
- 522
- Joined
- Jan 12, 2016
- Messages
- 4,095
- Reaction score
- 26,876
- Location
- Iowa City
But it regained all its dignity.
cus_deluxe
terms of service violator
- Local time
- 12:05 PM
- User ID
- 393
- Joined
- Jan 3, 2016
- Messages
- 5,464
- Reaction score
- 25,934
- Location
- Michigan
10-20 seconds. For a 14k-5400 pull like all these graphs.
With a 1.5 min idle/rest between pulls. Sometimes it takes 3-6 pulls to get a good one.
Lol.
huskyboy
Sorta a husqvarna guy...
- Local time
- 12:05 PM
- User ID
- 1352
- Joined
- May 30, 2016
- Messages
- 10,025
- Reaction score
- 43,464
- Location
- Ct
It was hanging with a stock 390xp with a muffler mod when I had it here in cut speed. Less torque with a long bar obviously than the 390... but it was cutting right with it with a short bar. The little saw that could. Makes more power than it’s chassis or oiler will let it realistically pull.
What are the times on those?
