What's on your bench?

[Mastermind]

 

[Mark71gtx]

No but I added some pics above if it helps

It certainly helped. I do not have any of those. Man those look cool!

 

[DSS]

almost look to be the same type as my 133SG also has, same look and placement.
My bet is oil vent

Edit:
https://www.partstree.com/parts/husqvarna/saws-chainsaw/281-husqvarna-chainsaw-1990-01/crankcase/
https://www.partstree.com/parts/husqvarna/parts/501839401/

Mine leaks there too. How you get that sum beech out of there?

 

[DSS]

I happen to be working on one of those as well. How do you change the seal in the oil pump? Do you remove the gear assembly? Do you trust the large oiler o-ring to seal, or put a little sealant around it for good measure? That is where I stopped last night...

Don't remove the gear. I put a little three bond on the o ring. Drive the seal out the front

 

[Mastermind]

 

[Onan18]

Ok not exactly on my bench, heating element went out in the old dryer and I was tired of messing with it. Five year warranty made in Ripon Wisconsin, U.S.A!

Joe

 

[Stump Shot]

How about changing the seal? Do you remove the oiler gear running across it? Drive it in from the back?

Do not remove gear, will tap out easy with punch, support pump good while doing this. With appropriate driver, drive new seal in backwards, leave a little lip showing. No sealer needed, but O ring should be renewed, a little grease here is OK. Also make sure small O ring is on pump, these get lost easily, replacement recommended, as well as pickup hose.

 

[Stump Shot]

Oh cylinder, where art thou?

 

[Mastermind]

View attachment 47064
View attachment 47065

Ok not exactly on my bench, heating element went out in the old dryer and I was tired of messing with it. Five year warranty made in Ripon Wisconsin, U.S.A!

Joe

Speed Queen huh? I knew a few girls that liked the speed back in the day too.

 

[dall]

Speed Queen huh? I knew a few girls that liked the speed back in the day too.

was your nickname randy the rabbit ?

 

[Brewz]

Got a part number?

501 76 59-01

 

[Mastermind]

Quitting time.....

 

[Stump Shot]

Quitting time.....

View attachment 47076 View attachment 47077

You must be exhausted.

 

[Sty57]

It never fails.......I decided to thin the herd. Get rid of a few projects.
A day or two later.....they start following me home.....

 

[Mark71gtx]

It's not thinning the herd, it's making room...

 

[Sty57]

I just can't leave them sit at the dump.....it's like going to the pound and having all them puppy's looking at you when ya leave.

 

[Onan18]

Speed Queen huh? I knew a few girls that liked the speed back in the day too.

Punny, very punny. In all seriousness though I highly recommend a Speed Queen over any other brand. Not only made in the U.S.A. but they are laundromat grade, over 80% of Speed Queens business is laundromats, so EVERYTHING they build has to be to that standard.

 

[Stump Shot]

Wonder how well this ran with the inlet lever set like this. Tillitson HS.

 

[Motorhead]

Smokey

 

[Tor R]

Mine leaks there too. How you get that sum beech out of there?

I would think you find the channel extremely close to the oil cap, at least on 133 the channel is where the oil cap threads stop.

This is how it would be done on 133:


The tool