What's on your bench?

[Sloughfoot]

026 carb
You gotta be smarter than the trigger.

 

[bulletpruf]

Good lookin setup. What chamber?

.308

 

[heimannm]

With the use of a heat gun putty knife, small screwdrivers, and a good measure of patience I was able to save the major gaskets.



In case you were curious.



Mark

 

[Partner]

I'm often curious

 

[Chainsaw-57]

Again, interesting serial Mark.

HOS

 

[heimannm]

Model Profile: 424

 

[heimannm]

That serial number makes me wonder if it was some sort of "Experimental" model?

At the same time, other Clinton saws I have seen also have a X in the serial number.





Mark

 

[Mastermind]

Fubared MS362 getting some love.

 

[heimannm]

This one crossed the bench today, just blew a few cobwebs off, wiped it down a bit, and move it up to the display. Very low on compression and the starter cup is so badly worn that the pawls will not catch any more. For the time being, it will just sit there and look used. From Mike Acres site I believe this is a model HB.





The fuel tank and carburetor remain in position, while the engine rotates 90 degrees in either direction as needed for felling cuts.





From Mike Acres site, the HB was an improved version of the HA and introduced the direct drive chainsaw to the world.

Mark