Saw video thread

[gurwald]

Someone should put a carb on that MS500i iSaw

 

[RI Chevy]

Not!!!

 

[N8TE]

I might be wrong in my thoughts but I've always thought the more oil you add the more you cause a lean condition by reducing fuel.

 

[huskyboy]

I might be wrong in my thoughts but I've always thought the more oil you add the more you cause a lean condition by reducing fuel.

Your right. Which is why you compensate on a normal saw by fattening up the mixture. Mtronic can probably only go so far. Probably similar with autotune as well.

 

[N8TE]

Your right. Which is why you compensate on a normal saw by fattening up the mixture. Mtronic can probably only go so far. Probably similar with autotune as well.

Right...moving parts only need so much lube....no sense over doing it.

 

[huskyboy]

11.15 seconds

11.83 seconds

11.67 seconds

 

[RI Chevy]

LOL. Nice Mason. Ya got a big toof sticking down on your last saw video. [emoji16]

 

[huskyboy]

LOL. Nice Mason. Ya got a big toof sticking down on your last saw video.

Yup... clutch cover adjuster wouldn’t fit the bar and the one from my 372 did for whatever reason. Rather odd looking .

 

[redlight066]

8T square ground. I’ve used that chain to test a couple of saws. Not dull, just not super sharp. It runs ok. I may go back in and touch it up a little

 

[redlight066]

 

[Redbull661]

 

[Edwad]

Awesome video!

 

[Dub11]

Hot damn!!!!

 

[Wilhelm]

MMWS Dolmar PS-6100

 

[Wilhelm]

Dolmar PS-7300 , same chain and log as in the previous video

 

[Wilhelm]

MMWS Dolmar PS-6100 running a Oregon Vanguard loop with modified rakers and sharpened with an Archer FastFiler sharpening jig, log is semi dry beech

 

[huskyboy]

Dolmar PS-7300 , same chain and log as in the previous video

It was about 4 or 5 seconds faster than the 6100. Maybe in smaller wood it would be closer?

 

[Wilhelm]

It was about 4 or 5 seconds faster than the 6100. Maybe in smaller wood it would be closer?

The PS-7300 should be faster even if not ported, much more cc over the PS-6100.

 

[Nutball]

My 660 kit saw, ported for working torque, not racing. It definitely lacks race rpms. 9t .325 Archer

 

[Nutball]

Wow. Those rakers look very low...

Now you know why