Saw video thread

[jmssaws]

Looks pretty good J

Think it will beat these stihls?

 

[dolmarkid]

Time to go to the wood pile

 

[Brewz]

Yep 394
It's a beast but it should be as much grinding as i did.
Raising a port almost 15 degrees takes some work.

What did you raìse 15 degrees?

 

[jmssaws]

What did you raìse 15 degrees?

Transfers were raised 15 degrees and the exhaust was raised 12 degrees

 

[Brewz]

I take it the jug got lowered a lot to need it ?

 

[Deets066]

Think it will beat these stihls?

Not if I did it, I'd have a hard time keep the right angles and direction raising the uppers 15 degrees. They have to be huge

 

[jmssaws]

Not if I did it, I'd have a hard time keep the right angles and direction raising the uppers 15 degrees. They have to be huge

It's a massive amount of grinding to bring the entire transfer up that much.

Wear your right angle smooth out.

 

[jmssaws]

Raising the exhaust that far is a lot of grinding also,I raise the entire roof to the flange and straight edge it to make sure it's flat all the way. I think it makes a difference.

 

[Deets066]

Raising the exhaust that far is a lot of grinding also,I raise the entire roof to the flange and straight edge it to make sure it's flat all the way. I think it makes a difference.

Top side of flange get thin?

 

[jmssaws]

Top side of flange get thin?

Lot of meat on a 394.

 

[drf256]

Looks damn good Jason.

Looks like it might beat the unicorn for a few cuts, until all the screws come loose.

 

[Brewz]

Looks damn good Jason.

Looks like it might beat the unicorn for a few cuts, until all the screws come loose.

Just need a magnet tray and put em back in when you touch up the chain

 

[jmssaws]

Looks damn good Jason.

Looks like it might beat the unicorn for a few cuts, until all the screws come loose.

LOL,it does have a bunch of odd bolts holding it together.
Need the whole tool box to take it apart.

I'll run them this morning and see where it's at.

 

[trooney]

LOL,it does have a bunch of odd bolts holding it together.
Need the whole tool box to take it apart.

I'll run them this morning and see where it's at.

Troof!!

 

[jmssaws]

Here's the 24" video
Going to get the 32" 404 video now

 

[jmssaws]

Any predictions on the 32" video?

 

[paragonbuilder]

Any predictions on the 32" video?

394 FTW!

 

[jmssaws]

394 FTW!

064 is a couple tenths ahead I think

 

[paragonbuilder]

064 is a couple tenths ahead I think

Damn!

 

[paragonbuilder]

064 is a couple tenths ahead I think

Super close then? Are you going to go bigger?