ported 661 with a carb

[Scott0154]

 

[Stihl working Hard]

This is the new unlimited module (coil) I put on my MMWS ported 661 works great

 

[Moparmyway]

This is the new unlimited module (coil) I put on my MMWS ported 661 works greatView attachment 16487

Mine tops out at 13,000-13,100 with the new coil

 

[Stihl working Hard]

Mine tops out at 13,000-13,100 with the new coil

Is it the same part # as mine because mine pulls harder than with the stock coil iam taking my saw to my dealer on saturday to put it on there computer to see what RPM its pulling saw was running a little lean after a long cut for a few seconds until it settled down no problems now though the coil did change the fuel parameters

 

[Stihl working Hard]

These are the numbers on the top of my unlimited coil

 

[Moparmyway]

Yup, mine pulls harder also ......... Could be getting some help to pull so hard though

 

[ABarrick]

I just got 13920 on a stock 661 with mtronic on my tto tach. If i can figure out how to post a video i will

How old is your saw? Just curious as mine is an early model and it no way would hit 13000 even let alone 13900. Mine sounds more like 12 to my ear.

 

[Scott0154]

My coil is a 4700 c so its an older one. I want to post the video but can't figure it out

 

[Scott0154]

 

[Moparmyway]

She is a strong one

 

[CR500]

does the maxflow fit back under the stock cover?

 

[jmssaws]

does the maxflow fit back under the stock cover?

It don't on a 66 but I don't know on a 661

 

[Moparmyway]

does the maxflow fit back under the stock cover?

On a 661 it does

 

[CR500]

so basically if I take an old HD! and take the media out of it and wrap the maxflow filter around it I should be good right? What actually holds the filter tight?

Or should I know get another 661 filter and modify it for the MAX flow system?

Still anxiously waiting for the 661 MAX flow kits to be released....

 

[Moparmyway]

How old is your saw? Just curious as mine is an early model and it no way would hit 13000 even let alone 13900. Mine sounds more like 12 to my ear.

Mine is hitting about 12,000 in the cut in the video above

 

[jmssaws]

so basically if I take an old HD! and take the media out of it and wrap the maxflow filter around it I should be good right? What actually holds the filter tight?

Or should I know get another 661 filter and modify it for the MAX flow system?

Still anxiously waiting for the 661 MAX flow kits to be released....

I'll fix you up with one.

 

[CR500]

I'll fix you up with one.

Hey man don't short yourself!!! If you need me to send filter or piston let me know lol

Can you pm me your paypal?

 

[jmssaws]

Hey man don't short yourself!!! If you need me to send filter or piston let me know lol

Can you pm me your paypal?

I don't have PayPal. Send me the green maxflow filter, don't need anything else.

Mail me a check

 

[CR500]

*s-word I thought you had paypal.... would of mailed money with the saw. Chit my bad man!!!

 

[jmssaws]

I ain't worried about it. I'll get a PayPal account this week. Been needing one for a while