ported 661 with a carb

[sawmikaze]

I'm gunna try the HD2 with no cover, I doubt it will plug up like it does with the cover on. I think it's been tried, might even be in this thread.

But with the cover on, they suck

Ive tried that first plate with an outerwear on the HD2 under the max flow filter cover on my 461s..its not too bad.

 

[sawmikaze]

That will change in their new offering

Not according to the ported saw polishing advisory board.

 

[sawmikaze]

Best Answer

still wanna pinch my cheeks ?

 

[junkman]

 

[sawmikaze]

My mother made the same face when i was born.

I aint rapped tight.

 

[Moparmyway]

Not according to the ported saw polishing advisory board.

Well, I have better contacts than they do, plus I have a dream

 

[sawmikaze]

I'm gunna try the HD2 with no cover, I doubt it will plug up like it does with the cover on. I think it's been tried, might even be in this thread.

But with the cover on, they suck

Use the max flow plates , it seals better.

 

[Deets066]

Use the max flow plates , it seals better.

I'll probly make one on the mill out of aluminum

 

[Moparmyway]

I'll probly make one on the mill out of aluminum

I'll have a mill in a few years, I'd like to have one sooner, but I know the reality of life

 

[sawmikaze]

I'll probly make one on the mill out of aluminum

For a plate to hold an air filter on a chainsaw ?

hoooollly dogballs..you guys are serious.

 

[Deets066]

For a plate to hold an air filter on a chainsaw ?

hoooollly dogballs..you guys are serious.

I have aluminum, it don't take that much

 

[Deets066]

For a plate to hold an air filter on a chainsaw ?

hoooollly dogballs..you guys are serious.

I could make one in an hour or so, how long would it take to buy one and wait for shipping

 

[Moparmyway]

Played with the timing in another cylinder ....,,..., holy dog balls