No case replacement. Maybe I should have said fairly early, instead of one of the first. It's SKU number 970493100 and Husqvarna lists the oldest at 970493132
Lower # than Huskys Oldest listed SKU.
Been great, probably my all time favorite. Muffler did start cracking from the corner of my muffler mod after I tried welding deflector on. Replaced it with exile muffler that I like much better. Mine also came with updated purge bulb line, reinforced dog mount, and intake boot though.
Yes
Thanks for posting this. Something I can plan for over time with my 592, especially when it’s subzero….seems everything breaks when it gets that cold. I believe the fitting for the dampers are more robust for the part ending in 901. The softer one seems to have a much smaller end that fits into the bottom of the airbox so stands to reason it would be weaker and also likely to fail more quickly. Probably only solution is to have spares on hand and routinely check and replace after a few years or once you feel they’ve soften too much.
Thanks, I did not look at an xpg ipl when I searched for parts. There is two different intakes for the xp as well. One has a hole in the partition wall that accepts a holder for the ignition spark wire. Which I believe is what I found even though I don't have the holder thingy. I'll have to block it off or something, or leave it be as it's fairly small.
Yeah, it looks like the hole in the partition is for the rubber damper that the previous version ignition wires passed through. I’m sure that’s a non critical update and don’t see why the old partition couldn’t be used with any of the intake boots, but then again I’ve not actually replaced any of those parts yet so I could be dead wrong on that. I wish they made better IPL updates to explain things to saw owners…..but maybe they do and just keep them tight to the vest and only allow official service dealers access to them. Good luck with your repairs……real bummer when I saw as good as that goes down.
593257901 for 585 592 xp
He misses @Mastermind having his occasional tirades.
I purchased the last two an outfit in New Hamshire had, if it wasn't for that, these two saws would be sitting here until they weren't needed anymore, as Husqvarna doesn't have any.
Sadly, sans the expletives, he's not wrong on his assessment of Husqvarna's "new normal".
Husqvarna here is a minimum of 6mos out for any parts. It is so bad that the main dealer/seller here, D&B, has threatened to drop the entire Husq. line from all their stores.
That supersedes the other number I believe. Had both on the description when I bought the ones I foundeded.What about the newer part number which supersedes the 901 part? I think they have it in stock here:
well, you are on the moon.
