High Quality Chainsaw Bars Husqvarna Toys Hockfire Saws

Cobbling

Dub11

Saw R skeery
GoldMember
Local time
11:57 AM
User ID
2014
Joined
Oct 21, 2016
Messages
34,615
Reaction score
147,240
Location
Kansas
Country flag
Next we hammer this down to shoe and I apply all the clamps while it cures.
20250717_114525.jpg
The next day I'll trim the leather so it matches the profile of the welt and add this rubber midsole. Make sure to rough up the leather first and I'll apply 2 layers of glue to the leather since the first will get absorbed pretty good.20250721_092742.jpg


Some say the leather provides a better bond to the sole and other say a rubber to rubber is better if it's going to be exposed to the elements because leather will swell and shrink with water exposure. Since these will all be stitched to the boots I'm making sure well have a rubber to rubber bond.
 

Dub11

Saw R skeery
GoldMember
Local time
11:57 AM
User ID
2014
Joined
Oct 21, 2016
Messages
34,615
Reaction score
147,240
Location
Kansas
Country flag
So now on to sole stitching. I start out lining out my stitch count per inch. Some say the more SPI the better but I think leaving more meat between the holes has to be stronger in the long run.20250730_125933.jpg
I found when working with this thicker leather it's a lot safety to pre drill with a 3/32 bit. Running a awl through feel like play Russian roulette with the palm of your hand.

If I was using a thinner midsole the needle would just glide right through.
 
Last edited:

Dub11

Saw R skeery
GoldMember
Local time
11:57 AM
User ID
2014
Joined
Oct 21, 2016
Messages
34,615
Reaction score
147,240
Location
Kansas
Country flag
Once again I start out at the inside of the heal with close to 20ft of cord and run it through a hole then even it out. I run the needle through the top since the bottom thread will be beat up a little it allows the top thread you see to remain looking cleaner.20250804_102159.jpg
And when you making the lock stitch and pulling it tight its important to leave a little slack so it doesn't crush down the leather or potentially rip the leather welt.20250804_102240.jpg
Like this.
20250804_102254.jpg
Not like this.
 

Dub11

Saw R skeery
GoldMember
Local time
11:57 AM
User ID
2014
Joined
Oct 21, 2016
Messages
34,615
Reaction score
147,240
Location
Kansas
Country flag

hacskaroly

2100 Fanclub Member
Yearly GoldMember
Local time
9:57 AM
User ID
27954
Joined
Nov 24, 2023
Messages
2,255
Reaction score
7,342
Location
Northern Idaho, Ehh
Country flag
So this project is going on a hiatus now.
This has been a cool thread and very interesting to see the process. It looks like a fun/useful hobby. Too bad I don't have any extra time or money or else I might look into this...lol. Good luck with the move and getting everything set back up quickly!
 
Top