High Quality Chainsaw Bars Husqvarna Toys

Another chainsaw dyno...

mdavlee

Hillbilly grinder
Local time
9:39 AM
User ID
279
Joined
Dec 28, 2015
Messages
14,194
Reaction score
64,602
Location
TN
Country flag
Whenever you are ready.

Sure hope this Printer works as a backup. If the software shows up I will be able to use the laptop and a regular printer.





I have heard those are flat nasty... can be hard on recoils if you don't know how to start them though

I built one for Walt up in the mountains of Arizona that busted a recoil at my house. It was 235 or so there with no break in and 185 at his elevation.
 

Red97

Mastermind Approved!
GoldMember
Local time
9:39 AM
User ID
385
Joined
Jan 2, 2016
Messages
7,452
Reaction score
53,843
Location
MI
Country flag
I built one for Walt up in the mountains of Arizona that busted a recoil at my house. It was 235 or so there with no break in and 185 at his elevation.

Them darn recoils maybe a kick start would be better.
 
Last edited:

Red97

Mastermind Approved!
GoldMember
Local time
9:39 AM
User ID
385
Joined
Jan 2, 2016
Messages
7,452
Reaction score
53,843
Location
MI
Country flag
Well the printer prints, but dosent seem to communicate with my readout box...

Matched all the settings according to the manual. Sure hope it's just th printer.
20200515_134819.jpg

Software did show up, have to wait for the correct cable for that. Sure hope I can get the software working.
20200515_150536.jpg

This is a whole new level of control.
 

jk14

Pinnacle OPE Member
GoldMember
Local time
9:39 AM
User ID
799
Joined
Feb 5, 2016
Messages
1,152
Reaction score
5,481
Location
Glenside Pa.
Country flag
026,260 are stock, and the 260 will prolly get ported.

044 is dual port and squish set ex raised widen light mods.

046 is stock, maybe a dual port.

066 is dual port, maybe big bore? Supposed to be a runner.

395 is the first one I ported. Squish set, band cut normal numbers etc..

May post some of the numbers.


Whatcha running for fuel/oil mix for your dyno runs? If you don't mind me asking.
 

Red97

Mastermind Approved!
GoldMember
Local time
9:39 AM
User ID
385
Joined
Jan 2, 2016
Messages
7,452
Reaction score
53,843
Location
MI
Country flag
A thermocouple plug washer recording cylinder temps would add to the dyno's box of tricks. Keeping saws in the safe zone and also used as a tuning aid.

I have the channels for that along with 4 more thermocouple. and about 10 other options that I don't have the slightest clue about.

Fully optioned harness.

Baby steps

Baby steps

Need to get the software hooked up next. Then learn to use that.
 

ayoungtexan

I tell a lot of lies
Local time
8:39 AM
User ID
12269
Joined
Apr 15, 2020
Messages
3,077
Reaction score
14,356
Location
Dallas, Texas
Top