What's on your bench?

[Deets066]

Be lucky if there's anything left over worth its weight in chit when this is done.
View attachment 171988

You need some of this...

 

[Deets066]

Heat gun makes it so much easier taking all the old rubber parts out

 

[spencerpaving]

Finished but still on bench....Lil five cube pipe....

Sent from my Pixel using Tapatalk

 

[spencerpaving]

Whoops here it is...

Sent from my Pixel using Tapatalk

 

[Deets066]

Whoops here it is...

Sent from my Pixel using Tapatalk

Mr. Brett... when I finish this project of mine I may have you check this pipe I have or maybe build a new one

 

[spencerpaving]

Sounds good....Let me know....May the force be with you on this project

 

[GCJenks204]

A two into one deal here, should be interesting.... View attachment 171965

Could always change it up for something blue...

 

[Stump Shot]

Could always change it up for something blue...

if I would pan to the right....

 

[GCJenks204]

if I would pan to the right....

Air filter finally came in?

 

[Deets066]

Sounds good....Let me know....May the force be with you on this project

Ordered some filler rod gunna learn to weld mag here shortly

 

[Stump Shot]

Air filter finally came in?

I'll get with you on the details here shortly.

 

[tickbitintn]

Well I found it under all the *s-word that was on it!

Sent from my XT1635-01 using Tapatalk

 

[tickbitintn]

Put this Lil feller on it... It floods every time I try to start it. Went through the carb quickly the first time as it had been sitting a bit and didn't pay too much attention to it other than cleaning out some stale fuel and debris.

Sent from my XT1635-01 using Tapatalk

 

[spencerpaving]

Ordered some filler rod gunna learn to weld mag here shortly

Awesome...I find it welds just like aluminum or just a little easier

 

[StuntCockWelder]

Ordered some filler rod gunna learn to weld mag here shortly

I bet it was expensive I know the az92 is pricey

 

[JohnnyBlade]

Put this Lil feller on it... It floods every time I try to start it. Went through the carb quickly the first time as it had been sitting a bit and didn't pay too much attention to it other than cleaning out some stale fuel and debris.

Sent from my XT1635-01 using Tapatalk

Is that a ps-510?

 

[Deets066]

I bet it was expensive I know the az92 is pricey

That’s what I got

 

[Deets066]

 

[Stump Shot]

Something blue...

 

[MG porting]

Both pin locaters still there?
Looks to me "dents" are about the size of one.

Sent from my XT1635-01 using Tapatalk

Yep there still intact someone put a new piston and rings and wrist pin barring in it and I'm guessing they didn't flush the case so now I'm the one gets to fix someone else's Bobo.