What's on your bench?

[drf256]

This is an HJ clip.

 

[singinwoodwackr]

This is an HJ clip.

View attachment 484642

I have those all over my shop…somewhere…probably with the circlips…

 

[Wilhelm]

I cut down a brand new never used driveline, I borrowed the shorter one from a coworker to serve as a starting point.




This much off to make the driveline fit.
Yeah, I cut it three times rather than cutting off too much at once.
Pictured is just the outer driveline shaft, I cut outer & inner shaft, and outer & inner guard tube three times.

 

[jacktheripper]

Just ran my 041 Super in some large pieces of pine. I’m pretty dang impressed. The thing just keeps chugging. It’s not too bad on vibration, and it’s built like a tank. I kind of like the fact that it isn’t super pretty. Maybe I’ll keep it around as a powerful old beater. Cost me practically nothing.

 

[jacktheripper]

2171 and 365sp on the bench. 2171 needs transfer cleaned up and new piston. 365 needs a crank, bearings, and top end.

 

[stretch5881]

Just ran my 041 Super in some large pieces of pine. I’m pretty dang impressed. The thing just keeps chugging. It’s not too bad on vibration, and it’s built like a tank. I kind of like the fact that it isn’t super pretty. Maybe I’ll keep it around as a powerful old beater. Cost me practically nothing.

Not pretty means less chance of it being stolen.

 

[Tor R]

This one has a long history, as a 242 collector there are two I don't have, KS top end and Gilardoni 241B top end.
I had one with 241B, my friend was really keen on it, after much if and but I gave it to him as a gift, I had spent 5 years hunting down exactly that one. Later he traded it away for something else, and I was really disappointed.

So, I got hold of another one after a few years of searching, this ome is from year 1995, but I've had it in a box for quite a few years, something around 3-4 years.
Now it was time to swap wear parts and a simple porting, it got the original exhaust, a cat with most of the inside removed afterwards and the project is finished.
This one will stay with me!





Needs a couple of decals, but that will be another search.

 

[David Young]

This one has a long history, as a 242 collector there are two I don't have, KS top end and Gilardoni 241B top end.
I had one with 241B, my friend was really keen on it, after much if and but I gave it to him as a gift, I had spent 5 years hunting down exactly that one. Later he traded it away for something else, and I was really disappointed.

So, I got hold of another one after a few years of searching, this ome is from year 1995, but I've had it in a box for quite a few years, something around 3-4 years.
Now it was time to swap wear parts and a simple porting, it got the original exhaust, a cat with most of the inside removed afterwards and the project is finished.
This one will stay with me!

View attachment 484764

View attachment 484765

Needs a couple of decals, but that will be another search.

was the 241 b the best jug?

 

[Tor R]

was the 241 b the best jug?

In stock version I think 241B was the best, but all XP Mahle versions were also very good. If I had to choose between them I would probably say 241B.
The one, I have only seen two of them, KS, is the one I think is of the lowest quality, at least when it comes to port qualities.