What's on your bench?

[Maintenance Chief]

The 441 lives again
It is heavier than I expected at 17.2#, PO
View attachment 480614View attachment 480615View attachment 480616
I suppose I should replace that missing muffler hole cap,

Probably 1 of my favorite saws for work, both felling and firewood.
A little woods porting really wakes these up! Too much and you get a Tinman turd.

 

[Tor R]

Husqvarna 40, year 1978 get maintance:

 

[Tor R]

Sunday, today is the time for my 444SG from 1984 to get a new seals....and a little G troubleshooting too.

The victim:

 

[Tor R]

Getting some generator surgery late on Sunday night:



It's not the first, and it won't be the last!

 

[Shane¹]

Heated handle 7900 solo stroker started port work. Got most of it done might raise transfers just a touch more.

 

[Tor R]

3 done, work for tomorrow buy epoxy glue and finish them,

 

[Hinerman]

 

[bulletpruf]

Rebuilt a close ratio T-10 for my budget '72 Javelin endurance race project (24 Hours of Lemons). Now I need to build a backup trans.

 

[stretch5881]

Rebuilt a close ratio T-10 for my budget '72 Javelin endurance race project (24 Hours of Lemons). Now I need to build a backup trans.

View attachment 481808

View attachment 481809

View attachment 481807

Tough transmission. I had one in my Charger. The car was restored over 25 years ago and the same transmission is still in it. That and the Dana 60.

 

[bulletpruf]

Tough transmission. I had one in my Charger. The car was restored over 25 years ago and the same transmission is still in it. That and the Dana 60.

They're actually not super strong, but should work for what I'm doing because we won't be doing any hard launches. Strongest trans from that era would be an A-833 hemi 4 speed.

 

[stretch5881]

They're actually not super strong, but should work for what I'm doing because we won't be doing any hard launches. Strongest trans from that era would be an A-833 hemi 4 speed.

Mine saw drag racing with super sticky tires. I blew a couple of expensive clutches but no other driveline issues.

 

[bulletpruf]

Mine saw drag racing with super sticky tires. I blew a couple of expensive clutches but no other driveline issues.

Got any pics of the car? What engine? 440?

 

[oddsaws]

Ms400 on the bench today. Low compression

 

[EFSM]

Ms400 on the bench today. Low compression

View attachment 481855

View attachment 481856






View attachment 481857

Low on oil? Somehow lean?