What's on your bench?

[JKNW]

What will you use to re-wrap it?

Probably just going to get a simple hockey tape job.

Got the top dropped, had to order a little tubing to finish the leg back by the cylinder.



Proportions worked out exactly how I wanted, looks like mini me compared to the 461. The big saw has the same handlebar installed.

 

[59billy]

Probably just going to get a simple hockey tape job.

Got the top dropped, had to order a little tubing to finish the leg back by the cylinder.

View attachment 478594

Proportions worked out exactly how I wanted, looks like mini me compared to the 461. The big saw has the same handlebar installed.

View attachment 478593

That's a slick job there.

 

[jacktheripper]

Got my second 910 project done!

 

[president]

The other Jonsereds 910e is also cleaning up nicely. Replaced a rear AV bushing and rear handle assembly. This is going to get new fuel tank vent, impulse line, fuel line and filter, and carb kit.

I had a good one, but sold it for fear of damaging that coil mounted to the
plug wire! What were they on when they thought of that?

 

[singinwoodwackr]

Probably just going to get a simple hockey tape job.

Got the top dropped, had to order a little tubing to finish the leg back by the cylinder.

View attachment 478594

Proportions worked out exactly how I wanted, looks like mini me compared to the 461. The big saw has the same handlebar installed.

View attachment 478593

Part 3 should be interesting