What's on your bench?

[Chainmale]

I put a side tensioner on mine and an 18".050 3/8. 7 tooth rim sprocket and Picco Super full chisel. With the muffler opened up, adjustable carb and timing advance it pulls the longer bar in 14" hardwood better than expected.

How does it go oiling an 18"?

 

[Sloughfoot]

How does it go oiling an 18"?

Noticeably drier than with the 16". Might be an issue.

 

[Sloughfoot]

Noticeably drier than with the 16". Might be an issue.

Did a few more cuts this evening. It's oiling well enough to keep the bar from getting hot in one 10" hardwood cut. Warms up cutting back to back 10" cuts. Good news is it pulled 9500 rpm in the cut with the rakers down to .035. Max rpm is around 13,500. Is drinking a lot more gas.

 

[afleetcommand]

Back sifting through the pile of junk.... and re-engaging with an old favorite chassis