What's on your bench?

[dustinwilt68]

Lots on my benches,7910 and 7900 waiting on new color powdered cases, 262XP ported and waiting on a piston, 440 ported and waiting on a piston, 550 xpg ported first cylinder, about to start a second cylinder for a customer.

 

[Mattyo]

View attachment 235345

Ouch.

View attachment 235346

View attachment 235347

View attachment 235348

Did you actually get paid for those nice welds very nice

 

[Czed]

Another reason to use Motoseal. 400 saws started as soon as they’re back together, no failures. Just need half a brain to keep it from oozing out everywhere

Q-tip

 

[WillG]

Just about ready to go! Just a few odds and ends to tie up, fuel and oil, test run and wash!

Sent from my E6910 using Tapatalk

 

[MustangMike]

I've got one of their generators with the same make engine and very happy with it so far.

Great bang for the $.

 

[WillG]

My dad's been using the predator engines for 5-6 years now with no problems.

Sent from my E6910 using Tapatalk

 

[Onan18]

Did you actually get paid for those nice welds very nice

Wish I could say that I am that good, but honestly I am not. Truth is when you are using one of these anyone can run a nice bead.

 

[M2theB]

A 250 for partz scrounge, Dolmar PS-540 rehab, 039 to share a bar and chain for the Dolmar and a Curb Alert Poulan 3614 now on the market after a fuel line and carb clean.

 

[Mattyo]

Wish I could say that I am that good, but the truth is I'm not. Truth is when you are using one of these anyone can run a nice bead.

View attachment 235455

Love my mig 180as. A little smaller than that one but my welds are not quite as nice

 

[drf256]

Finished up a 681 long block. The owner needs this to start easy, so I added something different. It also has a decomp.

This muffler is right up there with the 562 in terms of suckage. If you cut the baffle out, you need a spacer in the rear so that the muff bolts don’t pull through the guide tubes. Had to use the remnant ears off the baffle and a few washers for proper spacing and tig braze them to the rear of the muffler body. Again, what a PITA.

 

[drf256]

 

[drf256]

 

[drf256]

 

[RI Chevy]

Nice work as always Al!

 

[Mkinslow]

Working on a knife for a member here

Sent from my SM-G892A using Tapatalk

 

[Johnmn]

254 progress, we could use a muffler support if anyone has an extra laying around......

 

[WillG]

Road service call to get an 8 hp Briggs running. A carb clean and adjustment had it running sweet.

Sent from my E6910 using Tapatalk

Edit to add video of it running..

 

[Lcfd1124]

192 got some new crank bearings

 

[N8TE]

Installing some new vanes today.

 

[M2theB]

Installing some new vanes today.View attachment 235713

I used to do a lot of those on aluminum with my Dad and Brother. The jig is a lot different!