What's on your bench?

[Simondo]

Yea Old MS460......

View attachment 45665

Unless my eyes deceive me ...thats the new ringless low running resistance version that make 200000 rpm !!

 

[Mastermind]

Unless my eyes deceive me ...thats the new ringless low running resistance version that make 200000 rpm !!

It has rings in the grooves.......all both of em.

 

[Simondo]

It has rings in the grooves.......all both of em.

Glasses ....! I need glasses !

 

[Black Dog Chainsaw]

too much stihl stuff on the bench... Can someone come take all these cream-sickles away from here?!?!?!?

 

[Stihlbro]

Ugh!!!!

 

[super3]

too much stihl stuff on the bench... Can someone come take all these cream-sickles away from here?!?!?!?

I done the same to a 359 today if that helps.

 

[Onan18]

I done the same to a 359 today if that helps.

Ironic, I had a 359 on the bench today for a new ring, partition, clutch, and service.

 

[a. palmer jr.]

Got in a couple more today, an 028 that I need to get running and a MS310 that doesn't have compression so I'll put in a 390 kit. I also have an MS290 that I'll probably rebuild next Spring.

 

[mdavlee]

Hey Mike,

I got that saw for doing a couple of 365 cyls for Genius back in August. Had a broken case half and a leaking tank.

I have a pile of aluminum that came with it that it didn't need now.

I may have to find a tank for it yet.

Ahh. Tanks are not easily found used yet. I have a cylinder for one sitting here.

 

[bigbadbob]

Did the seals on a 268.
BBB

 

[bigbadbob]

 

[Simondo]

View attachment 45765

That for real !!

 

[bigbadbob]

That for real !!

Not sure off FB,,, but I know some that could do that,,
BBB

 

[dall]

it would slide over the pulleys easier and nothing to line up lol

 

[Sty57]

View attachment 45765

Get Well Soon Valves.......

 

[Likesaws]

Just picked this up, not sure what to do with it low compression bad air filter. Being tight cost the saw.

 

[Stump Shot]

Just picked this up, not sure what to do with it low compression bad air filter. Being tight cost the saw. View attachment 45792View attachment 45793View attachment 45794

If you decide you do not want to mess with it let me know, I may be interested.

 

[Tor R]

Something @David Young spoked about, 346/350 carb and swapp shafts to fit 242.
242's venturi is 13,5mm while 346 has 15,0mm venturi.

The test carb and saw:


If this work out I know where my two HDA 182 will go

 

[Stump Shot]

Donor crank in, 2nd time was a charm, somehow managed to put it in backwards the first time. Doh!!! After I specifically told myself to pay attention, I blame being in a rush to press it in while the case was still hot, and old age. Recovered OK though.
Smoozed up the exhaust port after cleaning this KS "B" P&C . Ever so slowly coming together as 1973 meets 1983. Should be a real thumper.Haha

 

[X 66 stang347 X]

Nice. Where did you find a case gasket? I've thought about finding one for my dad's L77 so if I ever need to go into it that far. Parts are getting hard to find