What's on your bench?

[Glock37]

I've got far more work to do already than I can handle. lol

Youll get it in do time !


Sent from my iPhone using Tapatalk

 

[rattler]

Fighting a air leak on the boot on this one

 

[rattler]

 

[Mastermind]

The 372 boot will work in a pinch Mike.

 

[MustangMike]

Looks like some "Tall Boys" there Randy!

 

[rattler]

The 372 boot will work in a pinch Mike.

Ok I was wondering about that Thank you Mr Randy

 

[Mastermind]

Done for the day.......finally.

 

[Glock37]

Ship one too me


Sent from my iPhone using Tapatalk

 

[Glock37]

Done for the day.......finally.

View attachment 37922

Are they all the same

Is squish the same on all of them too start with


Sent from my iPad using Tapatalk

 

[Mastermind]

Are they all the same

Is squish the same on all of them too start with


Sent from my iPad using Tapatalk

Evidently they are real close. I cut .030 from the squish, and .045 from the base on them all. There is less than .003 variance in the finished clearance now.

 

[Glock37]

So do you need the whole saw or just a cylinder On this model since it seem the tolerances run pretty close ?


Sent from my iPhone using Tapatalk

 

[Mastermind]

So do you need the whole saw or just a cylinder On this model since it seem the tolerances run pretty close ?


Sent from my iPhone using Tapatalk

I still need the saw. The muffler is a pain in the ass, and the timing needs to be advanced. I also check final squish clearance, and check port timing on the saw.

 

[Glock37]

I figured. Damn ! But you the man !


Sent from my iPhone using Tapatalk

 

[psuiewalsh]

Done for the day.......finally.

View attachment 37922

What's with the .015 pop up notation??

 

[Mastermind]

What's with the .015 pop up notation??

I was wondering who would ask about that. That's in reference to a MS201T. It's tough to cut the base on those, so I lose the base gasket and do a .015 offset pop-up.

 

[Tor R]

took me a bit time to figure out why the 13" NK bar couldn't fit well on my newest 242...


Both has got maintance and ready for the winter thought to swap ring on the oldest one but 155 psi is okey


550 xpg, straight gas scored, was insecure if I had cleaned the crankarea good so I pulled the seals, cheap insurance compared to get bit and pieces in a new jug
Tomorrow work is to remove casting, and put it together.

 

[Mastermind]

@Tor R

I make a video for you on right angle handpiece chatter. It's uploading now.

 

[Tor R]

@Tor R

I make a video for you on right angle handpiece chatter. It's uploading now.

Thanks Randy
I appreaciate your help, I felt it was very difficult to get the result as I wanted, it went better after awhile, but chatter was a problem for me

 

[Mastermind]

http://opeforum.com/threads/how-to-...ing-a-right-angle-handpiece.4519/#post-206727

 

[paragonbuilder]

I was wondering who would ask about that. That's in reference to a MS201T. It's tough to cut the base on those, so I lose the base gasket and do a .015 offset pop-up.

So why cut a pop up, vs cutting the squish band on this saw? Better numbers? Gets the exhaust higher?