What's on your bench?

[67L36Driver]

Had a 044 dropped off , won't start. Hmmm got spark. Got fuel. Very oily around the exhaust outlet. Best to investigate muffler.



Yup poor thing couldn't sneeze [emoji17]



Ditch the screen and put a dual port front on it. Bang! Starts and runs like a cut cat. [emoji16] tune and handed back.

Outboard motor oil? Or plain old 30wt.

 

[VinceGU05]

I am nearly think in used diesel oil

 

[stihl saws]

I'm changing crank bearings in a 026 today.

 

[beaglebriar]

Touching up some chains with the timberline.

 

[Isaac]

Had a 044 dropped off , won't start. Hmmm got spark. Got fuel. Very oily around the exhaust outlet. Best to investigate muffler.



Yup poor thing couldn't sneeze [emoji17]



Ditch the screen and put a dual port front on it. Bang! Starts and runs like a cut cat. [emoji16] tune and handed back.

A picture looking through the muffler of my 044 [emoji24]



Sent from my iPhone using Tapatalk

 

[exSW]

Not a dang thing. Fixing these things has become slightly addictive.
My next project has yet to arrive.

 

[VinceGU05]

A picture looking through the muffler of my 044 [emoji24]



Sent from my iPhone using Tapatalk

From one extreme to another [emoji15]

 

[jake wells]

Had a 044 dropped off , won't start. Hmmm got spark. Got fuel. Very oily around the exhaust outlet. Best to investigate muffler.



Yup poor thing couldn't sneeze [emoji17]



Ditch the screen and put a dual port front on it. Bang! Starts and runs like a cut cat. [emoji16] tune and handed back.

i like my mufflers like i like my women wet and nasty lol.

 

[Mag Craft]

Well Isaac do you know what caused it. Some nasty looking scoring.

 

[drf256]

@Canadian farm boy and @dall MS360's. Bot base and squish cut. One jug ported.

 

[drf256]

 

[VinceGU05]

My 044 12mm back together after a squish and timing adjustments and muffler mod.

 

[Brewz]

This one is my next job.
Project two-one-zero-zero-see-dee
I am very keen to get it together, cylinder mildly ported, V Stack (in the mail) K&N pod filter and nice open muffler

 

[Brewz]

2100 oil seals are easy..... same as 394/395.
Is the case gasket the same as any other model?
I am not having much luck finding a case gasket

Also, I need side bar plate. I am guessing a 288/395 bar plate would fit or be close enough to work, being the same bar paturn

 

[Iron.and.bark]

Brewz, I will see if my local dealer has an old gasket in stock tomorrow for you.

 

[Brewz]

Cheers mate.
I went to my local husky dealer but they said "good luck"

 

[Brewz]

To be honest, for a one off like this, I can probably just put some ink or marking blue on a case half and press it onto a sheet of gasket material and just cut one out.
Actually, I think that is what I will do.

An OEM gasket will cost more than I paid for the saw

 

[Iron.and.bark]

Bearing blue mate, will do the trick.

 

[VinceGU05]

Ok I'll keep my spare gasket. [emoji1360]

 

[Brewz]

Vince, can you measure it.
Id be interested to know what thickness to use.