That’s really nice, Marshall. Did you do the grinding on the blade or do you buy the blanks that way?Knife for a member here. Good start so far
Sent from my SM-G892A using Tapatalk
All starts from steel and I cut my own blanks ,I mostly use 0-1 and 1095. I've got some old round sawmill blades that are L7 gotta get those too a friend who has a water jet to have them cut into strips.That’s really nice, Marshall. Did you do the grinding on the blade or do you buy the blanks that way?
How would it get so carbon built up like that. Thats crazy.Echo PB-250LN that wouldn't rev up. Haven't seen one this bad in a while. Needed a carb and throttle cable too.
Sent from my E6810 using Tapatalk
How would it get so carbon built up like that. Thats crazy.
Sent from my SM-G950W using Tapatalk
What should he run in it Joe? [emoji848]Echos tend to carbon easily, add to that cheap mix and you see the results.
What should he run in it Joe? [emoji848]
Yup.Replacing electrical connectors on a pos can-am atv today.
Figured give another little tip to those who might not know. If you have to use a crimp on connector or splice. Strip a extra bit off and fold it back over (or double it over like I had to do on this one). This will usually be in further than your crimp. But what it does is make the wire practically impossible to pull out of the connector. Personally I prefer to solder and shrink tube, but that's not always a option.
View attachment 211139
Steven
Edit: really hate working on atvs!