Solo 665 thread

[stihl livin]

Come on deetsy, get to grinding on this thing already

 

[Deets066]

Come on deetsy, get to grinding on this thing already

Hopefully I'll get time to cut the jug tomorrow, first things first

 

[Mastermind]

How much skirt before freeport city?

 

[Deets066]

Bout .040, roughly

 

[Deets066]

Not much there

 

[Deets066]

I should have scribed a line and got a better mark to measure but.... there's enough for 25

 

[Mastermind]

25 should be plenty, hell they have a lot of compression stock I reckon.

 

[Deets066]

It should put my intake low enough that I won't have to change height with the grinder.

I want to keep some case compression in it, just in case I decide to grind some fingers in it

 

[Mastermind]

I've seen some wild looking grinding in some 7900 and other quad port jugs. If you wanna get wild with it......I got plenty of extra jugs.

 

[Deets066]

I've seen some wild looking grinding in some 7900 and other quad port jugs. If you wanna get wild with it......I got plenty of extra jugs.

 

[Lightning Performance]

Go 20. Be nice to that long stroked piston. If it chatters you' be sanding

 

[Deets066]

Pics of said "wild grinding"


Me and a few other guys have talked about ex. Side fingers.

 

[Deets066]

Go 20. Be nice to that long stroked piston. If it chatters you' be sanding

There is a lot of stuff gunna happen to this saw, none of it is gunna be nice to it. Lol

 

[Mastermind]

Pics of said "wild grinding"


Me and a few other guys have talked about ex. Side fingers.

I'm not keen on posting much stuff these days. Just been irritated.....

 

[Deets066]

I'm not keen on posting much stuff these days. Just been irritated.....

Understandable

 

[Deets066]

I'd like to leave the trans stock and port the intake and ex. To start with, just to see where my gains are at

 

[Mastermind]

Smart.

These tight transfers are the reason these saws run like they do.

 

[Deets066]

Smart.

These tight transfers are the reason these saws run like they do.

They look like they are angled almost perfectly too

 

[Red97]

Hopefully I'll get time to cut the jug tomorrow, first things first

Don't forget a pic on the lathe, that thing is NICE...

 

[Dub11]

Tight transfers and nice lathes this is starting to sound like some smut!!!