Saw video thread

[Deets066]

Looks like there very strong.

 

[Redfin]

Lightened 395 piston, carb from a 394, filter neck from a low top 288 and then I made a v-stack to go on that, 2100 muffler with a very large single port.

View attachment 60975 View attachment 60976

You do some nice work Man.

 

[Darin]

Still pretty fat in the vid, needs some fine tuning

You ever run any bigger than a 10 pin?

 

[Deets066]

You ever run any bigger than a 10 pin?

Nope, that's the biggest I got

 

[Darin]

I put a 10 pin 3/8 on my 797 and I pulls it good. As long as I don't lay on it, it don't seem to bog the clutch. Was gonna try an 11. I got a near new 2101XP with an 8pin 3/8 and it pulls it good on a 32" cannon superbar. Was gonna go 10 pin on it and 11 on the 797. Chainsaw Jim has a built 064 and that *f-wordr hauls ass.

 

[Darin]

It's running a 9 pin. Sounds strong enough to go 10 or 11. Don't drop the rakers too much and let the sprocket pick up the rest.

 

[srcarr52]

Nope, that's the biggest I got

Did you have to mod that bar at all to run the 10 pin? I tried to run a 10 pin on a normal bar, I could make one really fast cut and then spend 2 minutes putting the chain back on.

 

[Darin]

2101 running too rich on an 8 pin 3/8
075 running 8 pin 3/8
797 running rich has 7 pin .404, now running 10 pin 3/8 leaned out a bit.
All full skip

 

[Darin]

Big difference with 10 pin 3/8. Leaned out a bit and exhaust opened up some. Made about 25 cuts and haven't thrown a chain but the belly fattens up a bit on the 36" Oregon bar. Can probably fit an 11 before I have to modify the bar.

 

[Deets066]

Did you have to mod that bar at all to run the 10 pin? I tried to run a 10 pin on a normal bar, I could make one really fast cut and then spend 2 minutes putting the chain back on.

I milled the bar tail and opened the grooves at the tail. Also had to mill a new adjustment hole for the tensioner

 

[Chainsaw Jim]

That 797 sounds like a race buggy....a bad ass race buggy.

 

[Deets066]

 

[Deets066]

 

[Darin]

Thanks, it's been a mofo of a project for someone with no patience. It almost met a train a few times.

 

[trooney]

Nice freakin saw!!

 

[Deets066]

Nice freakin saw!!

It's a moobs ported 52mm 64

 

[Darin]

That thing friggin rips

 

[huskihl]

You been practicing I see

 

[Deets066]

You been practicing I see

First vid wasn't that good. Lol

 

[huskihl]

First vid wasn't that good. Lol

I'm gonna try and gain a couple years experience this weekend