Saw video thread

[WillG]

Cuts with the free Homelite 240, 340 to 346 conversion, 61 to 272 conversion, 034 and 051. Going to make another video cutting in some pine.

Sent from my E6910 using Tapatalk

 

[drf256]

Ran the 361. Was interested in weights. Both filled to the brim. Forgot to turn the oiler up on the 361. Hickory is knotty and second log. Its some tough shít for sure.

 

[WillG]

Cutting with the same saws as the last video with the exception of the 051 in pine.

Sent from my E6910 using Tapatalk

 

[MustangMike]

Sounds mean Al!

 

[WillG]

The Chainsaw Guys GTG yesterday in Sterling CT. Warning is about 20 minutes long!

Sent from my E6910 using Tapatalk

 

[RI Chevy]

They members on here Will?

 

[WillG]

They members on here Will?

They are not. Mike is on the chainsaw groups on Facebook.

Sent from my E6910 using Tapatalk

 

[RI Chevy]

OK. I'm just a forum guy here...
Not a cool youtuber or FB person.

 

[huskyboy]

 

[JT78]

Are both saws ported? (sorry if I missed it in the vid) I've run a few 394 that always felt a little more torquey than my 395 so kinda surprised it was slower, but my ported 395 is def a screamer. I tend to run 3/8 8 pin full chisel skip on my 42 never tried .404 on it I do enjoy having less cutters to sharpen though. I did put some full comp 3/8 on it once still have the chain had to swap back to the 7pin as it kept bogging in.

 

[huskyboy]

Are both saws ported? (sorry if I missed it in the vid) I've run a few 394 that always felt a little more torquey than my 395 so kinda surprised it was slower, but my ported 395 is def a screamer. I tend to run 3/8 8 pin full chisel skip on my 42 never tried .404 on it I do enjoy having less cutters to sharpen though. I did put some full comp 3/8 on it once still have the chain had to swap back to the 7pin as it kept bogging in.

Three saws were ported and by different people. The last 394 in the video is not ported, just basic mods (base gasket delete/muffler mod... ect.) .

 

[Canadian farm boy]

I ported 2 top ends for this saw. One top end has a stock oem piston and the other top end has a oem piston with a pop up. This is the stock piston top end. Hopefully tomorrow I’ll switch to the pop up and test run again.

 

[Deets066]

OK. I'm just a forum guy here...
Not a cool youtuber or FB person.

You should try it

 

[P.M.P.]

You should try it

Probably fit right in...

 

[RI Chevy]

Right after you both.

 

[ferris]

Why are u holding the dogs/the saw away from the log?

 

[huskihl]

@M2theB

 

[RI Chevy]

Why are u holding the dogs/the saw away from the log?

Makes for more consistent and even cutting when timing the cuts.

 

[RI Chevy]

Nice job on the 572 Kevin. Strong runner...[emoji106]

 

[JT78]

Makes for more consistent and even cutting when timing the cuts.

It also helps the saw run smoother so it doesn't get bogged in and stop the chain.