flywheel ... m8x1.0 and m10x1.0 both RH
the pitches for clutch side that I used are m10x1.0, m10x1.5 m12x1.0 m12x1.25 m14x1.0 m14x1.25 .... all in the kit... all LH thread
m8x1.0 and m10x1.0 both right hand
m10x1.0 and m10x1.5 both left hand
m12x1.0 and m12x 1.25 both left hand
m14x1.0 and m14x1.25 both left hand
Nice Frank! What was that box for originally? I need to do something like that with mine.
Another piece of the same styrofoam shaped and cutout (mirror image of tools) to fit top...(glued to lid)Now I need to put something in the top to keep the top layer of tools in place, if the box gets tipped over. Trying to figure out what I will use for that...
Shoot Mattyo a message...he will get you lined out if he has some available.What do these cost
What do these cost
Last I checked it was $170.
Last I checked it was $170.
I can Reach Dr. Matty if needed
He wanted us to delete some posts in this thread, but that's pretty silly considering that all he needs to do is reply.
Actually it goes back to "As Is", and the interpretation of the definition, with caveats.Hmmmm. So he's boycotting the site (and maybe even HLS) over not receiving some sort of preferential treatment.
Where have I seen that before? LOL