Ms362 exhaust leak.

[SawAddictedFarmer]

I pulled the jug on my 362 to check some stuff and after putting it back together it was leaking around the muffler where it bolts to the cylinder. I tried cleaning the muffler, gasket, and cylinder and putting it back together but it still leaks.
This is what's on there.

Anybody have a fix for this? Do I just need a new gasket?
Would this fit?

https://www.farmertec.com/Muffler-Gasket-For-Stihl-034-036-038-044-046-064-066-MS340-MS341-MS360-MS361-MS640-MS650-MS660-MS380-MS381-MS440-MS441-MS460-TS400-Chainsaw-1125-149-0601-p229589.html

Thanks!

 

[Stump Shot]

After a good run, retighten the two bolts on either side of the port holding the can on.
No, that gasket will not fit, I recommend the OEM gasket.

 

[dangerousatom]

If you have any copper flashing/sheet, make a copper gasket and heat shield combo. I have never hade one leak yet
.
.

 

[SawAddictedFarmer]

After a good run, retighten the two bolts on either side of the port holding the can on.
No, that gasket will not fit, I recommend the OEM gasket.

Thanks! I should be able to give it a try this afternoon.
The fact that it's oily from exhaust leaking out isn't going to matter?

 

[hacskaroly]

The fact that it's oily from exhaust leaking out isn't going to matter?

Just give it a good wipe down with some cleaner and you should be good to go.

 

[SawAddictedFarmer]

Just give it a good wipe down with some cleaner and you should be good to go.

Well messing with a hot muffler could be fun but I guess I can give it a go.

 

[hacskaroly]

Well messing with a hot muffler could be fun but I guess I can give it a go.

Use the hot mats out of the kitchen to handle the muffler and you should be good to go!!

Edit: Yeah, I didn't think that through, no you don't want to take it apart after running, just tighten down. Later if you can get a screwdriver with a paper towel or something to work in and wipe up the extra oil you should be good to go.

 

[Stump Shot]

Well messing with a hot muffler could be fun but I guess I can give it a go.

It's okay, let it cool down first, you want it to shrink back up after being expanded anyway.

 

[jacob j.]

Well messing with a hot muffler could be fun but I guess I can give it a go.

Make sure the exhaust screws aren't too long - that can cause a leak.

 

[dangerousatom]

Make sure the exhaust screws aren't too long - that can cause a leak.

All my saws like long screws.........