Chain help!

[huskihl]

I inquired about the dogs because oversized dogs have the effect of making a chain seem overly aggressive. To the point that a lightweight saw can get sucked into the dogs easily and bog

 

[atimmons101]

I currently have the WCS shorty dogs on it.

 

[lehman live edge slab]

I don’t know if maybe its computer just isn’t used to the new hardware and it just isn’t setting itself correctly. I did what Donny walker said and let kit just idle for 15 minutes just to let it do anything on a program level.

Just to let you know that doesn’t do anything if it’s out of parameters it’s out and needs recalibration with the mdg1. They adjust basically immediately to anything it can within its ability and if it’s outside the range it will end up running like crap or blown up maybe both.

 

[lehman live edge slab]

I currently have the WCS shorty dogs on it.

As Kevin said large dogs act like a wedge and as the saw gets pulled into the wood it actually will apply down force on the bar and chain. They like these?

 

[atimmons101]

those are the ones! I use the shorty version though because the bark here isn’t as think as out west!

 

[huskihl]

those are the ones! I use the shorty version though because the bark here isn’t as think as out west!

I have Egan dogs, which are about the same length as WCS Shorties. And I took an inch off the end of the Egan dogs. Put your stock dogs back on and try it and you’ll see the difference.

Long dogs force you to run non-aggressive chains, which pretty much eliminates the possibility of a chain that feeds on its own. So you’re always forced to use them even in small wood

 

[atimmons101]

Makes sense! Thanks for the help! I’ll give that a try!