Any Chinese chainsaw and chinese parts discussion

[hacskaroly]

OK. From the pic it didn't look like you could screw the screw into it.

I will have to take a look now, I might be confusing it with my 2100.

 

[Tor R]

Doesn't look like that one will work in my saw unless I add a ground wire. My saws only have one wire and screw to case for ground.

That's the same part number as the previous posted one. How does it ground to the crankcase?

You can dismantle the new switches for Husqvarna. As long as your old switch is new enough for that to be possible.

Then you move the grounding pin from your old switch to the MOM switch.

But be careful when dismantling them, it doesn't take much before they are also destroyed.

I haven't bought the mom switch yet, but I have dismantled quite a few of the standard switches.

 

[Czed]

That's the same part number as the previous posted one. How does it ground to the crankcase?

Just grind down the tab to fit the female connector.

 

[ammoaddict]

View attachment 444524
Just grind down the tab to fit the female connector.

Got it. I had forgotten the 372 had 2 wires. I was thinking about the 55 with the screw and 1 wire.

 

[Loony661]

Anybody else having trouble ordering straight from Farmertec? Last saw I ordered, I remember that I needed to use my credit card and not PayPal to get it to transact. This time however, no matter which option I choose, it won’t let me change the State to the correct one for my address without locking up the website..

 

[jakethesnake]

Might noodle a stump up with the Chinese saw today. Wind isn’t screaming out for a change.

 

[eric4]

I see that they now sell 'clones' of the CS620P cylinder/piston for $90-100. This is news to me! Not sure if any of y'all have noticed...

 

[StihlEchoingHusky]

Oil makes me sensitive

#Oil lives matter