Wicked 090

[Deets066]

Yikes!
Not much bearing surface for the spacer/jug to sit on.
So I milled the deck down to sit flush with the case. I needed a spacer under the jug anyway, so it will just be a little thicker is all.

 

[Deets066]

And here is where I stopped for the day.

 

[jacob j.]

Looking good, Mr. D...

 

[mgr1]

I'm no machinist?

 

[Armbru84]

Nice Deets!!

 

[Deets066]

I'm no machinist?

I can make a few things happen, but I wouldn’t be a pimple on a machinist’s ass

 

[HYPERSAWS]

Nice work

 

[spencerpaving]

Gonna be a monster...

 

[Deets066]

Gonna be a monster...

I’m hoping so, porting is next. I’m gunna pick your brain on what optimal would be for one of your fancy belly pipes.

 

[EvilRoySlade]

call me stupid but i don't think that crank is going to send the piston up and down, looks too linear

 

[Nighthunter]

running yet

 

[Deets066]

call me stupid but i don't think that crank is going to send the piston up and down, looks too linear

It’s beefy though....

 

[Deets066]

I made what looks like a nice cup for sippin whiskey.

 

[Deets066]

Gunna make it easy to transfer my new holes in the case.

 

[EJ mcnamara]

Nice work

 

[Deets066]

Nice work

Only problem is the wrist pin. Think I’m gunna have to weld up the end of the crank and bore it out. Then polish and heat treat.

 

[ktmtigger]

What about the wrist pin is causing so much work

Sent from my E6910 using Tapatalk

 

[Deets066]

What about the wrist pin is causing so much work

Sent from my E6910 using Tapatalk

It don’t fit

 

[ktmtigger]

Ahh right

Sent from my E6910 using Tapatalk

 

[Red97]

Only problem is the wrist pin. Think I’m gunna have to weld up the end of the crank and bore it out. Then polish and heat treat.

How far off is it?