What's on your bench?

[Cut4fun]

Me thinks it might be a oak, but dont know trees very well without leaves myself.
Tight rings and pretty hard to cut. Can run a 20" buried at one end and 32" buried at the crotch area.

 

[mikerudder]

Going to be my first split and rebuilt of a Husky!

Cleaning up the parts and making a list:

Bearings (best ones to order?)
Seals/case gasket
Air filter (low top)
Fuel line and filter
Impulse line
Carb/carb kit (what’s the best carb for these saws?)
Anything else I am going to need?
Anyone able to help out with the parts?
Thanks fellas!

 

[RI Chevy]

LOCTITE!!!

 

[WillG]

Not much on the home bench today. But started another Garmin installation at work today and finished up a Johnson 90 that was fighting me.

Sent from my E6910 using Tapatalk

 

[HYPERSAWS]

I guess I have an exhaust leak

 

[Tor R]

 

[czar800]

 

[PA Dan]

View attachment 226311

Whatcha got going on there buddy?

 

[czar800]

Whatcha got going on there buddy?

Good evening Dan. Guy I know call me wanting to get rid of them.

 

[PA Dan]

Good evening Dan. Guy I know call me wanting to get rid of them.

You know of any good homes?

 

[czar800]

You know of any good homes?

Not sure if it’s a good home or not, but that’s my bench.

 

[PA Dan]

Not sure if it’s a good home or not, but that’s my bench.

You know it is brother![emoji106]

 

[rogue60]

25cc of madness lol
I did some grinding in there and replaced the single ring piston for a double ring piston timing advance and gutted the muffler.

 

[USMC615]

Was on the bench earlier anyhow...mounted a Vortex VMX-3T 3x magnifier and Vortex Strikefire II red/green dot, UTG Recon 360 8”-12” bipod on another PSA .300 Blackout hog killer!

 

[justoldsaws]

I bet it got pissed revved and the clutch unthreaded into the cover

I dont think the clutch came loose, there's no mark on the clutch cover from the clutch nut, I think it was the broken piece got caught between the clutch and cover.

 

[huskyboy]

Probably some firewood hack ran it with a broken spring in the past and that dug into the clutch cover.

 

[Cut4fun]

Folks wanted to know the differences in 15 25 45 on the CRG. 48mm and 50mm OE no AI and NE air injection.

 

[kingOFgEEEks]

The haunted 394 is back on the bench. Is there a way to drill in an impulse passage on a WJ 115 to make it work on a 394? There’s a dimple in the casting that lines up with the impulse on the intake block, but I wanted to check before I go ruining a perfectly good carb...

 

[tickbitintn]

Not on but near...

Sent from my XT1635-01 using Tapatalk

 

[tickbitintn]

Finished this today.

Sent from my XT1635-01 using Tapatalk