What oil is best? and what ratio?

[mdavlee]

Here's one for the 372 saw I built with a head.

 

[RI Chevy]

Cool find Mike. Lol
So compression does not even factor in.

 

[X 66 stang347 X]

I bet that's way lower than what most people think. Me included. Im running 8.5:1 with 22psi of boost. And that's pretty low if comparing to a performance naturally aspirated engine.

 

[Joe Kidd]

Here's the link. Populate the fields and you're good to go.
http://www.torqsoft.net/compression-ratio.html

 

[X 66 stang347 X]

That's why cutting the squish band and base adds so much power over stock

 

[Joe Kidd]

Plus adding some Red Armor should make it stupid strong.

 

[mdavlee]

Cool find Mike. Lol
So compression does not even factor in.

The 372 is 235 lbs static too. The other is the 660 and would be around 200

 

[Keith Gandy]

Plus adding some Red Armor should make it stupid strong.

Got yours yet?

 

[Joe Kidd]

Got yours yet?

Yep. My next gallon of mix will be RA@40:1
Gotta work this weekend doing physical inventory so it'll be a couple weeks before I get to run any OPE.

 

[bwalker]

Did he fabricate the results then? Or was the laser temp gauge off? One can equate faster cuts with more power from saw all other things maintaining equal. His test results are very eye opening. You have to admit that. Come on now.

I havent looked at the test or results.
And ,no, I don't think RB fabricated the results.
However, there are so many un controlled variables in these tests it could be anything. And laser temp guns are not very accurate. I use them at work on a regular basis and even the most expensive ones are pretty coarse and not very repeatable.

 

[mdavlee]

What oil to mix for the GTG? I've got to have the best smelling saws there

 

[RI Chevy]

Lol. Go with Klotz if it is warm enough.

 

[X 66 stang347 X]

Then you can run this saw and lick the pipe

 

[mdavlee]

Lol. Go with Klotz if it is warm enough.

Original is fine down to 0 or colder. Probably what I'll go with. I need to go get another couple gallons of fuel. By the time I fill up what I'm taking I'll be out.

 

[Keith Gandy]

What oil to mix for the GTG? I've got to have the best smelling saws there

Kl200!!!

 

[CoreyB]

Then you can run this saw and lick the pipe

Is it me or is that just not impressive ?
I will leave this little 40cc not broken in saw here.

 

[X 66 stang347 X]

It kinda seemed like why even. I found it while I was researching a saw

 

[KenJax Tree]

Is it me or is that just not impressive ?
I will leave this little 40cc not broken in saw here.

The noise was impressive.

 

[Dub11]

Then you can run this saw and lick the pipe

I could of dropped my ms290 on that log and break it faster than he was cutting.

 

[mdavlee]

Kl200!!!

I figured I'll use my storage fuel up. It's over a year old now. VP 94 with KL200 if I run out of saber in 87.