What happens when you straight gas a saw?

[Egg Shooter]

Good enough?

Must have been running Amsoil lol.

 

[Wonkydonkey]

Good enough?

That’s not no 2 mix in fuel, you don’t get holes in pistons.. that’s other problems Afaik That’s lean running
And this is why I say this

 

[kanscruzer]

I think they put a metal rod in sparkplug hole to remove piston from the cylinder with a 3 lbs hammer ,,, you can feel the love

 

[Egg Shooter]

That’s not no 2 mix in fuel, you don’t get holes in pistons.. that’s other problems Afaik That’s lean running
And this is why I say this
View attachment 284808

I was making a funny lol.

 

[popopboat]

Alright, alright, no free likes for Jeff on your watch
Dumpster diving for this one to redempt myself.



BTW Hole was caused by piston stop while removing clutch, had almost no resistance until it broke through.

 

[Deets066]

You guys will never guess what happened here.

 

[Stevetheboatguy]

View attachment 284826

You guys will never guess what happened here.

Last time I saw that much dome erosion was on a snowmobile with a nos system.



Steven

 

[Deets066]

Last time I saw that much dome erosion was on a snowmobile with a nos system.



Steven

You got the snowmobile part right.

 

[5000+]

Trying to go for the thin ring look?

 

[Deets066]

Trying to go for the thin ring look?

Compression release for easy starting.

 

[Wonkydonkey]

So was it stuck open, and thus lean / low compression and ran hotter than it should even thou it’s water cooled

kinda looks like its a bit slappy in the boar

 

[Wonkydonkey]

I was making a funny lol.

yeh I guessed that

I was just replying to poppy boats poast. And his pic is not s-g.

 

[Deets066]

So was it stuck open, and thus lean / low compression and ran hotter than it should even thou it’s water cooled

kinda looks like its a bit slappy in the boar

Nope,
No compression release, that was a joke.

 

[kanscruzer]

Timing got advanced ?

 

[huskihl]

So was it stuck open, and thus lean / low compression and ran hotter than it should even thou it’s water cooled

kinda looks like its a bit slappy in the boar

I’ve actually had a decomp stick in on a ported saw and ran a tank through it before I realized it. There’s no scoring. No irregular marks inside. I’m not certain how a leaky decomp could ever cause a 2 stroke to go lean and score

 

[Deets066]

Timing got advanced ?

Nope

 

[Pincher]

Hey @Cooper264 , did you figure out if your saw is ok?

 

[Duce]

You poured oil into fuel tank on an oil injected motor. Ran it in cold weather with stock air filter modified. @Deets066

 

[Mastermind]

Take a piece of white paper and put some drops of the fuel on it. After it evaporates, the oil should be left behind. Try a sample from a can of each that still have a label to compare.

Genius.

Somebody Poast pitchers of all the damage they’ve done using too much oil. The rags you use to wipe off the excessive exhaust spooge will never look the same. Just throw them in the wood stove.

Repped.

 

[Deets066]

You poured oil into fuel tank on an oil injected motor. Ran it in cold weather with stock air filter modified. @Deets066

Nope