The Swap Meet Thread

[Mastermind]

Give that thing a couple turns and go to bed.

Best answer. I'm gonna replace the seal anyway........so lots of heat, two good twists, and lights out.

 

[Canadian farm boy]

Be careful with oxy acetylene. If you get that aluminum to hot it will begin to pop at you like popcorn

 

[Glock37]

There yours if you need them let me know


Sent from my iPhone using Tapatalk

 

[huskihl]

You know it bro. I've tried that with it hot, cold, farted on, and shat at too. LOL

I figured you had. Hell, I back the nut out so it's out past the crank to center a punch and hit the punch with a hammer on the crank end. Usually 2 or 3 whacks and it comes off.

 

[Mastermind]

There yours if you need them let me know


Sent from my iPhone using Tapatalk

You are the man........I'm probably gonna need them both. lol

 

[Glock37]

Ok ill box them up


Sent from my iPhone using Tapatalk

 

[Mastermind]

I figured you had. Hell, I back the nut out so it's out past the crank to center a punch and hit the punch with a hammer on the crank end. Usually 2 or 3 whacks and it comes off.

The worse one I had before this was on an old Homelite. It was nothing compared to this mfer.

 

[Mastermind]

I figured you had. Hell, I back the nut out so it's out past the crank to center a punch and hit the punch with a hammer on the crank end. Usually 2 or 3 whacks and it comes off.

Hang on to your flywheel Kevin. Mike is gonna send a crank and a FW.

 

[big t double]

Heat.

Exactly...light that whole motherfunker on fire.

 

[Mastermind]

Exactly...light that whole mother frenchie on fire.

And make a video?

 

[Glock37]

Is that the right number on crank


Sent from my iPhone using Tapatalk

 

[big t double]

And make a video?

Goes without sayin boss.

 

[Mastermind]

Is that the right number on crank


Sent from my iPhone using Tapatalk

LMAO. I still ain't got the gawd damn flywheel off Mike.

 

[Mastermind]

Goes without sayin boss.

Yes.......Yes it does.

 

[Canadian farm boy]

You took the nut off the end of the crank right??? Lol

 

[dall]

lol one is trying to get the flywheel off lol

 

[Glock37]

I wanted to say put your legs into but that wont work either !!!


Sent from my iPhone using Tapatalk

 

[Majorpayne]

LMAO. I still ain't got the gawd damn flywheel off Mike.

If you have room, through it in a deep freezer with the puller overnight and hit the flywheel with a heat gun in the morning.

 

[Stump Shot]

I should have one.

Let me know if you would care to part ways with one.

 

[Mastermind]

If you have room, through it in a deep freezer with the puller overnight and hit the flywheel with a heat gun in the morning.

I would......but we just killed a beef. No room in either freezer.