Husqvarna 350 build thread

[EFSM]

I’ve had better success with The Right Stuff than Dirko.

 

[Shane¹]

How's the cylinder looking Greg... Curious how this one is going to run. If it runs half as good as my 346 it will be a nice build

 

[old guy]

This was probably 5 years ago, I don't remember the details, maybe one I put a 346 on.
I have at least 3 of those blocks in parts bin, when it warms up (-19°f this morn.), I will go out & see how much difference the thickness is.

Measured 4 of em, thinnest was 1.332, thickest 1.340, so the one I ground must have been for a 346.

 

[farminkarman]

How's the cylinder looking Greg... Curious how this one is going to run. If it runs half as good as my 346 it will be a nice build

I haven’t had any time to work on it. I’ve been sick since the weekend

 

[Ajs2654]

Good Morning,
Last year I found a thread that had step by step instructions with pictures for the 350 to 346xp. I've recently tried searching for it and cannot find it. Does anyone know if this still exists?

 

[59billy]

Good Morning,
Last year I found a thread that had step by step instructions with pictures for the 350 to 346xp. I've recently tried searching for it and cannot find it. Does anyone know if this still exists?

This one?

And another good one.

@farminkarman not meaning to hijack your thread, buddy. This is just a subject dear to my heart.

 

[Ajs2654]

This one?

And another good one.

@farminkarman not meaning to hijack your thread, buddy. This is just a subject dear to my heart.

Thank you!