The Official JB Weld Fan Club Thread

[MG porting]

View attachment 182907

Lol.good one right there.

 

[Al Smith]

Some of this stuff works and some doesn't .Depends on what it is and were it's used .I once used some epoxy inside of a block of a John-Deere A below the ring travel .Some idiot tried pulling it down the road at 30 MPH to unstick a stuck engine and wrapped the rod around the crank like a pretzel and broke the bottom of one cylinder out .It also pulled the piston in two right at the pin .I welded the piece back in using pure nickle rod and it had some slight imperfections so thus the epoxy .That was over 35 years ago and still no problems I'm aware of .
Something like that I would feel okay with using .In the ring travel or a cylinder head I would not . BTW my favorite solvent is acetone .

 

[blsnelling]

Not sure, I would like to. Could throw this old EHP chain I have on one of my slow saws just for fun.

Us two worn out mules could maybe mosey down there together.

 

[Stump Shot]

 

[huskihl]

View attachment 183151

Will it hold threads?

 

[Woodpecker]

View attachment 183151

 

[Stump Shot]

 

[Stump Shot]

Will it hold threads?

http://opeforum.com/threads/2-series-husqvarna-top-cover-thread-repair.6649/#post-343154

 

[Woodpecker]

Spoiler alert: JB is the gooderest unless you use it on your wood

 

[Stump Shot]

Will it hold threads?

https://www.jbweld.com/products/marineweld-twin-tube

 

[tree monkey]

 

[Stump Shot]

This stuff has made some great repairs over the years, and they hold up!

 

[Stevetheboatguy]

Used this


To repair a quarter sized hole in a 362 fuel tank and the entire back half of the clutch cover. (Strictly did the repair for science) has held up for about a gal and a half of mix so far.



Didn't have any jb or marine tex on hand, but this stuff is holding up darn good.


Steven

 

[MG porting]

Just JB weld it and forget about it.

 

[Woodpecker]

Bump

 

[tree monkey]

 

[tree monkey]

 

[Dub11]

That's Mr. Stump Shot and yes all this BS over how a man chooses to dicker with a garden tool.

I use my saws for my pet rock farm I'll have you know.

Kevlar eh? Will this make *s-word bullet proof?

 

[Dub11]

Can I slather that right on top of the rust?

 

[Intoxsawcated]

Looks like treemonkey is building himself an epoxy saw.

Sent from my SM-S767VL using Tapatalk