Struggling 3-fo-six

[huskihl]

It's pretty hard to tell from pictures, and the lighting in that one is bad. Bend a piece of wire to 90deg so you can lay it on the cylinder wall and have the short tip in the transfer port for reference.

Giving up the good stuff

 

[drf256]

Uppers look HUGE

 

[Dolkitafreak]

Uppers look HUGE

They are, very huge. Oops

 

[srcarr52]

Uppers look HUGE

But it looks like the most of the grinding was done on the bottom of the transfers.

 

[Dolkitafreak]

But it looks like the most of the grinding was done on the bottom of the transfers.

The primaries yes, my burr got away from me when doing that corner, then I figured may as well make it even across the port. Obviously not optimal just something I struggle with occasionally.

 

[BarkersSaws]

They are, very huge. Oops

Thanks man some how I managed to get this cylinder to run.

https://youtube.com/shorts/IY53--OYAyI?feature=share

 

[Dolkitafreak]

Thanks man some how I managed to get this cylinder to run.

https://youtube.com/shorts/IY53--OYAyI?feature=share

I knew that epoxy would help but I didn’t expect the gains it had! I’d say beating a 262 with boosters and a WG is decent.

 

[drf256]

Saw looks great. I’m not understanding, it’s the same cylinder?

What made the gains happen?

 

[Dolkitafreak]

Saw looks great. I’m not understanding, it’s the same cylinder?

What made the gains happen?

Same cylinder, his house burnt down and had a 2150 carcass afterwards. Only change was improving the primary transfer direction via epoxy. No other ports were changed. Saw is freaky strong now and uglier than sin

 

[drf256]

Sorry to hear.

 

[BarkersSaws]

I knew that epoxy would help but I didn’t expect the gains it had! I’d say beating a 262 with boosters and a WG is decent.

I will have to say i was shocked how well it runs. The little epoxy did the trick.