Stihl 032 AV Electronic Trigger Unit

[Djj450]

Are there any solutions out there for replacing this faulty trigger unit

 

[SE#1]

There is another thread in this site that explains how to test and replace if necessary. I'll see if I can find it and attach. I remember reading it.

 

[SE#1]

https://www.google.com/url?sa=t&source=web&rct=j&opi=89978449&url=https://arboristsite.com/threads/stihl-032-av-electronic-need-help.168059/&ved=2ahUKEwil_ciMue-RAxXDmWoFHV8bLFYQFnoECGkQAQ&usg=AOvVaw3w4D20vSDV0qTKAW7vNZy9

 

[legdelimber]

Wasn't there someone doing repairs on some ignition units? I believe it it was bad capacitors needing replacement. Not sure what web site I saw it on.
Seems like the guy posted as "Foggy Sails" or something similar.

 

[SE#1]

Wasn't there someone doing repairs on some ignition units? I believe it it was bad capacitors needing replacement. Not sure what web site I saw it on.
Seems like the guy posted as "Foggy Sails" or something similar.

Yes sir, not every time is it the capacitor, but a majority has been my experience. Definitely worth investigating. I have never personally worked on this specific module, but have tested many others and the capacitor has been faulty on several occasions.

 

[Djj450]

https://www.google.com/url?sa=t&source=web&rct=j&opi=89978449&url=https://arboristsite.com/threads/stihl-032-av-electronic-need-help.168059/&ved=2ahUKEwil_ciMue-RAxXDmWoFHV8bLFYQFnoECGkQAQ&usg=AOvVaw3w4D20vSDV0qTKAW7vNZy9

There suggesting using the 031av module in that post but I'm hesitant in buying one just in case it doesn't work with my setup. The 032 IPL only shows 2 setups but the post mentions 4 different versions on the 032. One being points, the donut under flywheel, trigger unit and then the later electronic coil. Without seeing bulletins for the 032 changes

I was thinking of pulling the guts out of mine and having a go at repairing it. My coil tests good with resistances in spec and tested on a coil tester but get no spark when in the saw. What's the best way to remove the epoxy from the chip without mangling the casing?

 

[SE#1]

The epoxy is a real headache. I use tiny screw drivers and pics. Time consuming, much easier and faster to replace. That is a side project just for enjoyment, not if ya want to get her repaired.

 

[SE#1]

IGNITION CHIP FITS STIHL 030 031 031AV 032 C 020 AV, REPLACES POINTS & CONDENSER | eBay

BRIGGS AND STRATTON ENGINES MODEL, TYPE AND CODE ie: (427707, 1026-G1, 024211YB). KOHLER ENGINES MODEL, SPEC AND SERIAL ie: (CH25S, 45285, 25124582). TECHUMSEH ENGINES MODEL, SPEC AND SERIAL ie: (TVS95, 2201A, SERIAL).

www.ebay.com

 

[SE#1]

Look at this product I found on google.com https://share.google/4AbbvNqaGQWuyFXMy

 

[SE#1]

Are either of these a possibility?

 

[tree monkey]

1118-400-1001 should work. you might have to adjust timing. new from stihl $38.00