Somebody help me grease my pole

[Greenthorn]

I guess every shaft needs oiled now and then, my time is now.
I have a HT101 pole saw, every time I extend the pole, the shaft comes out of the gear box.
I am reading this title and what I wrote so far.....this might get interesting to say the least.
So, I don't like my shaft coming out when I extend my pole, is there a way to re-grease or graphite these shafts?
Or do I have some other problem going on? Springs broke? Bearing wore? There are no unusual vibrations and it works fine.....as long as I don't extend it.

 

[wildroamer]

I wouldn't touch that with a ... Well I just wouldn't...

 

[merc_man]

Sounds like its been used hard and put away wet.

 

[jake wells]

just pull the shaft out and use lithium grease on it and put it back together.

 

[hoskvarna]

I had one with same problem. Mine ended up bein the pole was not up tight at the clutch. Loosened up pushed it all the way retighten worked fine after that.


Sent from the hills

 

[CR888]

I don't think its a lube issue.