Saw video thread

[paragonbuilder]

I'm going to see if I can upload a vid of my 385 mike ported. Going to be cutting some ash today.

Mike Lee?
Mason we need to get together and do some cutting soon!

 

[huskyboy]

Mike Lee?
Mason we need to get together and do some cutting soon!

Yep Mike Lee and yes we do!

 

[paragonbuilder]

Yep Mike Lee and yes we do!

Sweet! Let's pick a Saturday and just do it.
Next gtg is May 6 btw.

 

[RI Chevy]

Cool!

 

[huskyboy]

It's about time I owned another ported saw . I have a cs600p echo I really need to get around to fixing, it was ported by a guy on arborist site Mitch (mweba) a few years ago.

 

[jmssaws]

Sweet! Let's pick a Saturday and just do it.
Next gtg is May 6 btw.

Come on over and we'll run saws today.
If you leave right now you'll be here tomorrow.

 

[huskyboy]

Sent from my iPhone using Tapatalk

 

[paragonbuilder]

Sent from my iPhone using Tapatalk

Looks strong Mason! And a nice sharp chain!! Looks like fun...

 

[mdavlee]

Sent from my iPhone using Tapatalk

Sounds like you got it tuned good.

 

[huskyboy]

I blocked 3 tanks worth of fuel with it. I think I had it tuned at 13,500/13,600. It's a strong ass saw

 

[X 66 stang347 X]

Sounds good. Don't forget our claw hammer [emoji6]

 

[dall]

stock 046 with a 461 carb at 14300

 

[mdavlee]

Sounds good Dallas. How much bigger is the 461 carb?

 

[dall]

im not sure the venturi is the same as the walbro i dont know the jet size but at 14300 it bogs in the cut but at 15300 you can push hard on it it is on my stock 046 right now id send it to someone to check out and let me know the differences

 

[huskyboy]

Sounds good. Don't forget our claw hammer [emoji6]

Haha yeah I left the axe at home but I really need to get myself a good hatchet/light axe or something

 

[paragonbuilder]

im not sure the venturi is the same as the walbro i dont know the jet size but at 14300 it bogs in the cut but at 15300 you can push hard on it it is on my stock 046 right now id send it to someone to check out and let me know the differences

It's stronger tuned higher Dallas?

 

[dall]

It's stronger tuned higher Dallas?

it was weak and bogged at the lower rpm

 

[paragonbuilder]

it was weak and bogged at the lower rpm

Interesting...

 

[RI Chevy]

This 440 ran well today. It was 4 stroking almost all the way through the cut at about 14900 RPM'S. I had to lean on the saw to stop the 4 stroking. Ran real well today. 24" bar with 3/8" Carlton full chisel chain.
Wood was a 23" diameter Locust crotch that was pretty hard.

@jmssaws

 

[Deets066]

461 carb will bolt right up to a 46 if you change choke arm